User manual MTD 4120

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual MTD 4120. We hope that this MTD 4120 user guide will be useful to you.


MTD 4120 : Download the complete user guide (1674 Ko)

Manual abstract: user guide MTD 4120

Detailed instructions for use are in the User's Guide.

[. . . ] € • • • • Never mow when the grass is wet enough to be slippery. Rear of Mower Front of Mower HANDLE Enclosed in carton are the : mower handle parts (1 foam grip, 1 top handle piece, 2 center handle pieces and 2 lower handle pieces ) and hardware package. Insert the top handle piece into the from grip, (for easier application, you can lubricate the inside of the from handle grip with dishwashing or liquid hand soap). [. . . ] Insert the 2 center handle piece into the left and right side of the top handle piece. Connect the right lower section with the left lower section and secure with two of the 1-3/8” long bolts and Nyloc nuts provided. Fasten the upper handle subassembly that your assembled in the preceding step to the lower handle subassembly using the four remaining 13/8” long bolts and Nyloc nuts provided. Be sure to tighten all hex nuts on the joints of the handle assembly of that none of the handle pieces are loose. After assembling the handle, fit the holes at the end of the lower portion of the handle on the left and right side, over the short posts extending out from the side plates. When the handle is in place over the posts, snap the “C clips” onto the slotted posts on both sides to prevent the handle from coming off. These units can be adjusted to offer a cutting height range from 1/2” to 1-3/4” simply by adjusting the roller assembly. To achieve the lowest cutting position, loosen and remove the nuts on both sides of the roller assembly. When the mower is properly lubricated and adjusted, sharpening should not be necessary for several years. However, the following steps will allow you to do the procedure yourself at relatively little expense. Spread a thin layer of lapping compound on the front edge of the reel blades. Adjust the cutter bar so that the cutter bar blade has light but firm contact with the reel blades across the full width of the cutter bar. WARNING: Do not overtighten the adjusting screws, as this could damage the cutter bar. Turning the reel blades backward, until the reel blades rotate retativety free and the front edge of the cutter bar blade is polished. Remove wheels; reverse pinions and pawls so that the beveled edge of the pawl is on the right. 4 2 WARNING: Clean any grinding compound or debris from the cutter bar blade, reel blades, pinions and pawls. [. . . ] Remove wheels; reverse pinions and pawls so that the beveled edge of the pawl is on the right. 4 2 WARNING: Clean any grinding compound or debris from the cutter bar blade, reel blades, pinions and pawls. Lubricate axle and pinion with a light film of wheel bearing grease and replace wheels and “C” clips. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE MTD 4120




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual MTD 4120 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.