User manual MTD 13A278M710

[. . . ] OPERATOR’S MANUAL SERIES 2000 TRACTOR Model Number GT 2521 w/48" Mower Deck IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLY Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forestcovered, brush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator. In the State of California the above is required by law (Section 4442 of the California Public Resources Code). A spark arrester for the muffler is available through your nearest engine authorized service dealer or contact the service department, P. O. [. . . ] Fill the crankcase until the oil level reaches the “FULL” mark on the dipstick (Refer to Figure 20). OPERATING RANGE A TRANSMISSION DIPSTICK Figure 23 26 ADDING TRANSMISSION OIL CAUTION Never overfill the transmission case. Damage or leakage may result if the oil level in the transmission case is below the “ADD” mark or over the “FULL” mark of the dipstick. For best results, fill to the “FULL” mark on the dipstick as opposed to adding a given quantity of oil. Refer to the LUBRICATION TABLE for information regarding the proper type of oil to add to the transmission case. Clean the area around the oil fill plug/dipstick to prevent debris from entering the transmission case. Remove the oil fill plug/dipstick from the oil fill port and SLOWLY pour oil into the oil fill port. Fill the transmission case until the oil level reaches the “FULL” mark on the dipstick (Refer to Figure 23). Reinstall the oil fill plug/dipstick securely into the oil fill port. 1. Clean the area around the transmission drain plug to prevent debris from entering the transmission case. Remove the drain plug and allow the transmission oil to drain into a clean container having a capacity of more than 6 quarts. Reinstall the drain plug (Refer to Figure 24). TRANSMISSION DRAIN PLUG Figure 24 CAUTION The oil fill plug/dipstick must be installed securely into the fill port at all times when the engine is operating. HYDROSTATIC DRIVE OIL FILTER CAUTION If the transmission oil is to be re-used, cover the container holding the drained oil to prevent contamination. Clean around the base of the transmission oil filter and remove the filter by turning it counterclockwise (Refer to Figure 25). CAUTION Never overfill the transmission case. Damage or leakage may result if the oil level in the transmission case is below the “ADD” mark or over the “FULL” mark of the dipstick. For best results, fill to the “FULL” mark on the dipstick as opposed to adding a given quantity of oil. Refer to the MAINTENANCE CHART for information regarding the frequency of the hydrostatic transmission oil filter replacement. The filter can be obtained through your Cub Cadet dealer under the part number 923-3014. Refer to the LUBRICATION TABLE for information regarding the oil capacity and the proper type of oil to pour into the transmission case. TRANSMISSION OIL FILTER Figure 25 27 4. Apply a light coating of clean transmission oil to the gasket of the new filter. Install the filter by turning it clockwise, by hand, until the gasket contacts the filter base on the transmission housing; then tighten the filter an additional 1/2 turn. Clean the area around the transmission oil fill plug/dipstick to prevent debris from entering the transmission case. Remove the oil fill plug/dipstick from the oil fill port and SLOWLY pour oil into the oil fill port. Fill the transmission case until the oil level reaches the “FULL” mark on the dipstick (Refer to Figure 22). [. . . ] After three months, the battery replacement credit is based on the months remaining in the twelve (12) month period dating back to the original date of sale. Any replacement battery will be warranted only for the remainder of the original warranty period. All belts are covered by a one (1) year limited warranty against defects in material and workmanship. This limited warranty does not provide coverage in the following cases: a. Routine maintenance items such as lubricants, filters, blade sharpening, tune-ups, brake adjustments, clutch adjustments, deck adjustments, and normal deterioration of the exterior finish due to use or exposure. [. . . ]