User manual MSI C847IS-P33

[. . . ] –  Technical Support If a problem arises with your system and no solution can be obtained from the user’s manual, please contact your place of purchase or local distributor. Alternatively, please try the following help resources for further guidance. Visit the MSI website for technical guide, BIOS updates, driver updates, and other information: http://www. Com/service/download Contact our technical staff at: http://support. [. . . ] MSI will comply with the product take back requirements at the end of life of MSI-branded products that are sold into the EU. 12 MS-7836 English Getting start Thank you for choosing the C847IS-P33/ C807IS-P33 series (MS-7836 v1. The C847IS-P33/ C807ISP33 series deliver a high performance and energy saving solution for BOX PCs. 0 ports Important To reach the 8-channel sound effect, the 7th and 8th channels must be output from front panel. For more information on compatible components, please visit http://www. Com/service/test-report If you need to purchase accessories and request the part numbers, you could search the product web page and find details on our web address below http://www. Php 15 Mounting Screw Holes When installing the mainboard, first install the necessary mounting stands required for a mainboard on the mounting plate in your computer case. If there is an I/O back plate that came with the computer case, please replace it with the I/O backplate that came with the mainboard package. The I/O backplate should snap easily into the computer case without the need for any screws. Align the mounting plate’s mounting stands with the screw holes on the mainboard and secure the mainboard with the screws provided with your computer case. For more information, please refer to the manual that came with the computer case. * Install the mainboard on a flat surface free from unnecessary debris. * To prevent damage to the mainboard, any contact between the mainboard circuitry and the computer case, except for the mounting stands, is prohibited. * Please make sure there are no loose metal components on the mainboard or within the computer case that may cause a short circuit of the mainboard. 16 The I/O ports should be facing toward the rear of the computer case. The memory module has an off-center notch on the bottom that will only allow it to fit one way into the DIMM slot. The plastic clips at each side of the DIMM slot will automatically close when the memory module is properly seat and an audible click should be heard. Manually check if the memory module has been locked in place by the DIMM slot’s side clips. Volt Notch Important * To ensure system stability, memory modules must be of the same type and density in Dual-Channel mode. * Due to the hardware limitation, you should follow the installing procedures: first memory modules, then graphics card. 17 JPWR1: ATX 24-Pin Power Connector This connector allows you to connect an ATX 24-pin power supply. To connect the ATX 24-pin power supply, align the power supply cable with the connector and firmly press the cable into the connector. [. . . ] LP 1 1 Keep Data Clear Data Important You can clear the CMOS RAM by shorting this jumper while the system is off. Do not clear the CMOS RAM while the system is on because it will damage the mainboard. 0 x1 slot 21 BIOS Setup Power on the computer and the system will start POST (Power On Self Test) process. When the message below appears on the screen, press <DEL> key to enter Setup. [. . . ]