User manual MSI 760GM-P34

[. . . ] X) Mainboard G52-76991X1  Copyright Notice The material in this document is the intellectual property of MICRO-STAR INTERNATIONAL. We take every care in the preparation of this document, but no guarantee is given as to the correctness of its contents. Our products are under continual improvement and we reserve the right to make changes without notice. Trademarks All trademarks in this manual are properties of their respective owners. [. . . ] * Install the mainboard on a flat surface free from unnecessary debris. * To prevent damage to the mainboard, any contact between the mainboard circuitry and the computer case, except for the mounting stands, is prohibited. * Please make sure there are no loose metal components on the mainboard or within the computer case that may cause a short circuit of the mainboard. The memory module has an off-center notch on the bottom that will only allow it to fit one way into the DIMM slot. The plastic clips at each side of the DIMM slot will automatically close when the memory module is properly seat and an audible click should be heard. Manually check if the memory module has been locked in place by the DIMM slot’s side clips. Volt Notch Important * To ensure system stability, memory modules must be of the same type and density in Dual-Channel mode. 17 JPWR1: ATX 24-Pin Power Connector This connector allows you to connect an ATX 24-pin power supply. To connect the ATX 24-pin power supply, align the power supply cable with the connector and firmly press the cable into the connector. If done correctly, the clip on the power cable should be hooked on the mainboard’s power connector. + 5 JPWR2: ATX 8-Pin Power Connector This connector provides 12V power to the CPU. 1 Important Make sure that all the power cables are securely connected to a proper ATX power supply to ensure stable operation of the mainboard. CPUFAN1, SYSFAN1, SYSFAN2: Fan Power Connectors The fan power connectors support system cooling fans with +12V. If the mainboard has a System Hardware Monitor chipset on-board, you must use a specially designed fan with a speed sensor to take advantage of the CPU fan control. Some system fans may not connect to the mainboard and will instead connect to the power supply directly. serial ATA devices include disk drives (HD) , solid state drives (SSD) , and optical drives (CD/ DVD/ Blu-Ray). Important * Please do not fold the Serial ATA cable at a 90-degree angle. However, it is recommended that the flat connector be connected to the mainboard for space saving purposes. JFP1, JFP2: Front Panel Connectors These connectors are for electrical connection to the front panel switches and LEDs. The JFP1 is compliant with Intel® Front Panel I/O Connectivity Design Guide. 2 Buz zer JCOM1: Serial Port Connector This connector is a 16550A high speed communication port that sends/receives 16 bytes FIFOs. 0 Expansion Connector This connector is designed for connecting high-speed USB peripherals such as USB HD s, digital cameras, MP3 players, printers, modems, and many others. [. . . ] Adjust Max Turbo Core Ratio This item is used to adjust the maximum CPU turbo core ratio. Adjust Turbo Core Ratio This item is used to adjust the CPU turbo core ratio. Unlock CPU Core This item allows you to unlock the additional cores, you could set it [Enabled] and then set Advanced Clock Calibration [Auto] in order to be able to activate the processor cores. When set to [Auto], the CPU will operate under the default number of cores. [. . . ]