User manual MR COFFEE IS REV1

[. . . ] Allow it to cool before putting on or taking off parts and before cleaning it. DO NOT operate any appliance with a damaged cord or plug or after the appliance malfunctions or has been damaged in any manner. DO NOT place this appliance on or near a hot gas or electric burner or in a heated oven. To disconnect, turn any control to off position then remove plug from wall outlet. [. . . ] First remove and then wash the water reservoir, lid, brew basket and filters in a mixture of mild detergent and water. Refer to the instructions below on "How to Brew Espresso" before removing the filter and brew basket. To clean the inside of the appliance, follow steps listed on "How to Brew Espresso" using water only. Do not immerse the appliance in water or attempt to reach any of its internal parts. Make sure the unit is switched off "O" and the side knob is in the off position " ". Fill the reservoir with water, you may either use a jar to fill it up or remove it from the unit and then fill it up under the tap. If you have removed it from the unit to fill up with water, please make sure to place it back tightly in its place. Fill the reservoir with the desired amount of water ensuring it ranges within the "MIN" and "MAX" markings on the tank. Select from the two filters that come with your unit depending on the amount of cups you wish to prepare (1 or 2 demitasses). Position brew basket underneath the brew head, attach brew basket by first moving retainer clip back, position handle so that the handle lines up with the unlocked icon " " on the brew head and fits into the groove. Then, slowly turn to right until brew basket is located at locked position (indicated by the icon below). Hold the pitcher under the frothing tube (which can be swiveled) so that the tip of the frothing tube is slightly immersed in the milk, press the steam button " ". The ready light " " will start blinking and once it becomes solid green again turn the side knob clockwise to the steam position " ". Gently move the pitcher in a circular motion around the steam nozzle for about 50 seconds (for 4oz, of milk) or longer if warmer milk is desired. REMEMBER: The milk and the pitcher should be very cold prior to frothing. When the milk has doubled in volume, or, if you are using a beverage thermometer, when the milk has reached 38°C (100°F), insert the frothing aid deeper into the milk to further heat the milk. Hot milk, do not let the tip of the frothing tube go above the surface of the milk. After frothing is completed, turn the control knob back to the off position " ". the steam " " and the brew " " lights will flash. The pump will run intermittently until the brew light and the steam light turn off). rEMEMBER: It is 1/3 espresso , 1/3 steamed milk and 1/3 frothed milk. Pour the espresso into a cup, which has the capacity of at least 150 ml (5 ounces). [. . . ] the frequency of cleaning depends upon the hardness of the water used. Make sure the side control knob is in the off position " ", the red switch is in the off position "O" and that the power cord is disconnected from the electrical outlet. Allow appliance to sit overnight with the vinegar solution in the water reservoir. Discard vinegar by removing the reservoir and turning it upside down over the sink. [. . . ]