User manual MR COFFEE FTX27

[. . . ] Turn the coffeemaker OFF and unplug the power cord from the power source when the coffeemaker and clock are not in use and before cleaning. Allow the coffeemaker parts to cool before putting on or taking off parts and before cleaning the appliance. Do not operate any appliance with a damaged power cord or power plug, or operate it after the appliance malfunctions, or has been damaged in any manner. Return this appliance only to the nearest Authorized Service Center for examination, repair or adjustment. [. . . ] When brewing is complete, turn your coffeemaker off, discard the water in the decanter and rinse the decanter, decanter lid, and filter basket. NOTE: Pressing any button before setting the clock will cause the clock to start keeping time from 12:00 a. This carbon-based water filter improves the taste of your coffee by removing up to 97% of the chlorine from the water you may use to brew your coffee. COFFEE® Filtration Friendly symbol on the bottom of your filter basket. Align the red indicator on the frame to the letter that corresponds with the month that you are using the disk for the first time. (Figure 2) NOTE: For optimum results, use the water filtration system with a permanent filter. The display will show the time you have programmed the coffee to brew. Follow "Adding Water and Ground Coffee" Instructions in the next section. Selecting and Measuring Ground Coffee: For best results, use a level tablespoon for ground coffee measurement. When you are done brewing your coffee, rinse the water filter with fresh water. To replace the water filter disks: twist the gray disk cover from your water filtration system. The green indicator light will turn on to signal that the coffeemaker is brewing. When the brewing cycle is complete the coffeemaker switches over to the warming mode. Your coffeemaker will keep your coffee hot for 2 hours, then automatically shut off. Thermal units will shut off immediatly after the brewing cycle is complete. While the coffee is brewing, the Pause n' Serve feture allows you to sneak a cup of coffee from the decanter. rEPLACE THE DECANTER ON THE WARMING PLATE WITHIN 30 SECONDS TO PREVENT OVERFLOW AND POSSIBLE INJURY. For Switch models: Press the ON/OFF Switch on the control panel so the green indicator light illuminates. the light indicates that the coffeemaker is on and that the brew cycle will begin. While the coffee is brewing, the Pause 'n Serve feature allows you to sneak a cup of coffee from the decanter. rEPLACE THE DECANTER ON THE WARMING PLATE WITHIN 30 SECONDS TO PREVENT OVERFLOW AND POSSIBLE INJURY. To turn off the coffeemaker, push the switch so the light is no longer illuminated. [. . . ] Suggested Decalcifying Interval: Type of Water Cleaning Frequency Soft Water Every 80 Brew Cycles Hard Water Every 40 Brew Cycles Water Filtration Disk Replacement: Your water filtration disk will need to be replaced once a month (approx. If the machine will not be in use for an extended period of time, rinse the water filter with running water and clean the coffeemaker before use. Cleaning the Decanter: Hard water can leave a whitish stain on the decanter, and coffee may then turn this stain brown. Fill the decanter with a solution of equal parts water and vinegar and let the solution stand in the decanter for approximately 20 minutes. [. . . ]