User manual MR COFFEE FTX21

[. . . ] Allow the coffeemaker parts to cool before putting on or taking off parts and before cleaning the appliance. Do not operate any appliance with a damaged power cord or power plug, or operate it after the appliance malfunctions, or has been damaged in any manner. Return this appliance only to the nearest Authorized Service Center for examination, repair or adjustment. Do not let the power cord hang over edge of table or counter, or allow it to come into contact with hot surfaces. [. . . ] (Follow these instruction closely for the best espresso making experience) 1. DO NOT attempt to unscrew Water Reservoir Cap OR remove Filter Holder without releasing pressure first. To release the pressure, immerse the tip of the Frothing Aid into a Frothing Pitcher with a small amount of water in it. sLOWLY TURN THE CONTROL KNOB TO THE STEAM POSITION AND RELEASE THE STEAM. When the Frothing Aid stops releasing steam, turn the Control Knob to the "OFF" position and slowly remove the Water Reservoir Cap. This will both release the pressure in your unit and clean the Frothing Aid. DO NOT hold back apply pressure Filter Retainer Clip when turning Filter into the Lock position. DO NOT remove the Filter Holder at any time during the brewing process or until pressure is relieved. DO NOT overfill the Filter with ground coffee, as this will cause an improper lock of the Filter Holder, which could result in leaking and damage the seal. DO NOT leave excess coffee grounds on the edge of the Filter Holder (Figure 1). Excess grounds on the edge will cause improper lock which could result in leaking and damage to the seal. Move the pitcher in a circular motion until desired amount of froth is reached. Hold froth back with a spoon while pouring your milk, then spoon the froth into the cup. (Figure 6) TO CLEAN: To clean Frothing Aid and release the pressure, hold a pitcher with a small amount of water under the Frothing Aid slowly turn the Control Knob to the STEAM position and release the steam. When the Frothing Aid stops releasing steam, turn the Control Knob to the "OFF" position and unplug the power cord. Ingredients and Measuring Guide Serving Size 1 cup 2 cups Fine Espresso Ground Coffee 2 cup mark on Filter 4 cup mark on Filter water (Cold) 2 oz. Fill to top of Metal band of Glass Carafe Milk (Skim or 2% froths more easily) 4 oz. Make sure to use the Filter Retainer Clip when discarding the grounds. After the machine has cooled and pressure has been released, remove the Filter Holder by sliding handle to the left away from the LOCK position. Discard the grounds, using the Filter Retainer Clip to hold the Filter in place while emptying. Using the Wrench built into the Scoop, unscrew the Frothing Tip and clean valve with a needle or toothpick. The Glass Carafe, Glass Carafe Lid, Filter, Filter Holder and Drip Tray can be washed with soapy water. [. . . ] If the appliance is cool and the pressure has been released, remove the Water Reservoir Cap and fill Reservoir with fresh, undiluted white household vinegar. Allow appliance to sit overnight with the vinegar solution in the Water Reservoir. Discard vinegar through the top opening of the Espresso Maker by turning the machine upside down over the sink. Rinse the Water Reservoir thoroughly with tap water by filling tank half full with water and then pouring the water back out into the sink, repeating this step twice. [. . . ]