User manual MR COFFEE FTTX85

[. . . ] Allow the coffeemaker parts to cool before putting on or taking off parts and before cleaning the appliance. Do not operate any appliance with a damaged power cord or power plug, or operate it after the appliance malfunctions, or has been damaged in any manner. Return this appliance only to the nearest Authorized Service Center for examination, repair or adjustment. Do not let the power cord hang over edge of table or counter, or allow it to come into contact with hot surfaces. [. . . ] NOTE: If you have selected any of the operating functions, the coffeemaker will act upon the last operation selected if the power is restored within 10 seconds after a power outage. The AM or PM indicator will light at the bottom of the display (Figures 1 and 2). Make sure your first cup of coffee is as good as can be by cleaning your MR. Then, run a brew cycle with water only, without adding coffee and coffee filter. When brewing is complete, turn your coffeemaker off, discard the water in the decanter and rinse the decanter, decanter lid, and filter basket. FIGURE 1 NOTE: Pressing any button before setting the clock will cause the clock to start keeping time from 12:00 a. While the display is in the clock mode, simply press the SET DELAY button (Figure 3) and, while the DELAY BREW yellow light is flashing, set the brew time by pressing the HOUR and MINUTE buttons (Figure 4). The display will show the time you have programmed the coffee to brew. If you press the SET DELAY button again or wait a few seconds, the display will switch back. For best results, use a level tablespoon for ground coffee measurement. This carbon-based water filter improves the taste of your coffee by removing up to 97% of the chlorine from the water you may use to brew your coffee. To turn the coffeemaker off, press the SELECT button until all lights turn off. You must first set the time for when you would like the coffeemaker to begin brewing your coffee as described in Setting the Clock and the Delay Brew Timer section. To activate DELAY BREW and program your coffeemaker to brew coffee at a later time, press the SELECT button twice (Figure 9). The coffeemaker is now set to automatically brew coffee at the pre-set later time. You can select the strength that you desire by pressing the BREW STRENGTH button. At the pre-set time, the green BREW NOW light will turn on and the DELAY BREW yellow light will turn off, indicating the brewing has started in the selected brew strength. The coffeemaker warmer plate will keep your coffee hot for 2 hours and then automatically turn off. As a safety feature, your coffeemaker will NOT start again automatically the next day. If you want your coffee to brew at the same time the following day, simply add a new filter, coffee and water and set DELAY BREW, by repeating Steps 2 and 3 above. The FRESH BREW TIMER feature displays the time since the coffee brewing cycle started. at the start of the brew cycle , the FRESH BREW TIMER feature will automatically be activated. [. . . ] Press the SELECT button until the red CLEAN indicator light turns on (Figure 10). Decanters ­ You can usually purchase a replacement decanter from the store where you purchased your coffeemaker. If you are unable to find a replacement, please visit us online at www. Doing business as Jarden Consumer Solutions or if in Canada, Sunbeam Corporation (Canada) Limited doing business as Jarden Consumer Solutions (collectively "JCS") warrants that for a period of one year from the date of purchase, this product will be free from defects in material and workmanship. [. . . ]