User manual MR COFFEE ECMP2

[. . . ] OPERATING INSTRUCTIONS FOR THE PUMP ESPRESSO/CAPPUCCINO MAKER MODEL ECMP2 BY MR. COFFEE When using electrical appliances, basic safely precautions should always be followed to reduce the risk of fire. electric shock, and/or injury t o persons, including the following: 1. To protect against electric shock, do not Immerse cord, plugs, or machine in water or other liquid. [. . . ] To rinse the Inside of the machine, follow steps for "How to Brew Espresso" on pages 6-7, using waler only. Please refer to page 5 for diagram of parts. Turn the machine OFF and make sure the brew switch is in the "0" OFF position. Remove the water reservoir by opening the lid and lifting up the reservoir handle. Fill the water reservoir with fresh, cold water to the top of the reservoir (29 ounce capacity). Never fill below the minimum line level indicated on the, outside of the reservoir. If the water reservoir is not Inserted properly Into the machine, the valve on the bottom of the reservoir will not be activated. The water reservoir lid will close only If the reservoir is prop erly Inserted and the valve is opened. The pump must be primed whenever the machine is being used for the first time or if not used In a long time. This procedure prepares the pump and fills the water boiler with water. PIace a frothing pitcher or large cup (with 16 ounce capacity) half full of water under the frothing tube. Leave the brew switch in the Turn the steam selector control nob to the ON position. After a few seconds a HOT stream of water will emerge from the frothing tube. Remove the filter holder by grabbing the filter handle and sliding l/4 to the left. Place either one of the filter baskets (1 =for one l-1/2 ounce cu of espresso: 2=for two 1-1/2 ounce cups o es resso) lnto the filter holder. Tamp (tap lightly, but do not pack) the cause grounds -the flat disc at the end of the handle of the spoon. Make sure filter retainer clip Is away from the filter basket. How To Brew Espresso 4. Place the filter holder underneath the brew head so that the handle is positioned to the left off center. Lift the filter holder up and Insert into the brew head and turn to the right. Make sure the filter holder is positioned to the right of the "min" (minimum) mark. Remove the water reservoir and fill to the top of the water reservoir capacity (29 ounce capacity) and place into the tank securely. Align either one or two demitasse cups under I , the filter holder on the drip tray. Make sure the steam control knob is in the OFF position, the on/off switch is OFF and the brew switch is on the "0" OFF position. When the brew light shuts off, turn the brew switch to the CUP position. [. . . ] Also, you will notice a build up of while deposits on the surface of the brew head. The frequency of cleaning depends upon the hardness of the water used. SUGGESTED CLEANING INTERVAL Clenning Frequency Type of Water Soft Water every 80 brew cycles Hard Water every 40 brew cycles Your espresso maker may be delimed using white household vinegar. Make sure the steam selector control knob is in the OFF position and that the plug is disconnected from the electrical outlet. [. . . ]