User manual MR COFFEE CBTU45

[. . . ] Allow the coffeemaker parts to cool before putting on or taking off parts and before cleaning the appliance. Do not operate any appliance with a damaged power cord or power plug, or operate it after the appliance malfunctions, or has been damaged in any manner. Return this appliance only to the nearest Authorized Service Center for examination, repair or adjustment. Do not let the power cord hang over edge of table or counter, or allow it to come into contact with hot surfaces. [. . . ] Make sure your first cup of coffee is as good as can be by cleaning your MR. Then, run a brew cycle with water only, without adding coffee and coffee filter. When brewing is complete, turn your coffeemaker off, discard the water in the decanter and rinse the decanter, decanter lid, and filter basket. While the display is in the clock mode, simply press the SET DELAY button (Figure 3) and, while the DELAY BREW yellow light is flashing, set the brew time by pressing the HOUR and MINUTE buttons (Figure 4). The display will show the time you have programmed the coffee to brew. If you press the SET DELAY button again or wait a few seconds, the display will switch back. For best results, use a level tablespoon for ground coffee measurement. Water Filtration System This carbon-based water filter improves the taste of your coffee by removing up to 97% of the chlorine from the water you may use to brew your coffee. COFFEE® Filtration Friendly symbol on the bottom of your filter basket. Align the red indicator on the frame to the letter that corresponds with the month that you are using the disk for the first time. NOTE: For optimum results, use the water filtration system with a permanent filter. The coffeemaker is now set to automatically brew coffee at the pre-set later time. You can select the strength that you desire by pressing the BREW STRENGTH button. At the pre-set time, the green BREW NOW light will turn on and the DELAY BREW yellow light will turn off, indicating the brewing has started in the selected brew strength. The coffeemaker warmer plate will keep your coffee hot for 2 hours and then automatically turn off. As a safety feature, your coffeemaker will NOT start again automatically the next day. If you want your coffee to brew at the same time the following day, simply add a new filter, coffee and water and set DELAY BREW, by repeating Steps 2 and 3 above. The FRESH BREWTM TIMER feature lets you know how long your coffee has been waiting for you. at the start of the brew cycle , the FRESH BREWTM TIMER feature will automatically be activated and the clock display will change to show the time since brewing began. Press the FRESH BREWTM TIMER button once (Figure 8) to go back to the clock function (while on the clock mode, the FRESH BREWTM TIMER feature will keep counting). The display will automatically change back to the clock after 2 hours or when the unit is turned off. NOTE: The BREW NOW green light must be on for the FRESH BREWTM TIMER feature to operate. [. . . ] Pause for 30 minutes (the CLEAN light will remain on to alert you that the process is active). Decanters ­ You can usually purchase a replacement decanter from the store where you purchased your coffeemaker. If you are unable to find a replacement, please visit us online at www. Doing business as Jarden Consumer Solutions or if in Canada, Sunbeam Corporation (Canada) Limited doing business as Jarden Consumer Solutions (collectively "JCS") warrants that for a period of one year from the date of purchase, this product will be free from defects in material and workmanship. [. . . ]