User manual MR COFFEE BVMC-KG1

[. . . ] Allow the coffeemaker parts to cool before putting on or taking off parts and before cleaning the appliance. Do not operate any appliance with a damaged power cord or power plug, or operate it after the appliance malfunctions, or has been damaged in any manner. Return this appliance only to the nearest Authorized Service Center for examination, repair or adjustment. Do not let the power cord hang over edge of table or counter, or allow it to come into contact with hot surfaces. [. . . ] When brewing is complete, turn your coffeemaker off, discard the water in the decanter and rinse the decanter, decanter lid, and filter basket. The AM or PM indicator will light at the bottom of the display (Figures 1 and 2). NOTE : Pressing any button before setting the clock will cause the clock to start keeping time from 6:00 a. To Set the Delay Brew Time: While the display is in the clock mode, simply press the SET DELAY button (Figure 3) and, while the DELAY BREW time is flashing, set the brew time by pressing the HOUR and MINUTE buttons. The display will show the time you have programmed the coffee to brew. If you press the SET DELAY button again or wait a few seconds, the display will switch back. Selecting and Measuring Ground Coffee For best results, use a level tablespoon for ground coffee measurement. This carbonbased water filter improves the taste of your coffee by removing up to 97% of the chlorine from the water you may use to brew your coffee. COFFEE® Filtration Friendly symbol on the bottom of your filter basket. Align the red indicator on the frame to the letter that corresponds with the month that you are using the disk for the first time. NOTE: For optimum results, use the water filtration system with a permanent filter. Press the FRESH BREWTM TIMER button once (Figure 8) and the clock time will change to show the amount of time that has passed since brewing completed. NOTE: The BREW NOW blue light must be on for the FRESH BREWTM TIMER feature to operate. The time and delay brew time cannot be set when the fresh brew time is displayed. You must first set the time for when you would like the coffeemaker to begin brewing your coffee as described in Setting the Clock and the Delay Brew Timer section. To activate DELAY BREW and program your coffeemaker to brew coffee at a later time, press the DELAY BREW button (Figure 9). The coffeemaker is now set to automatically brew coffee at the pre-set later time. You can select the strength that you desire by pressing the BREW STRENGTH button. At the pre-set time, the blue BREW NOW light will turn on and the DELAY BREW blue light will turn off, indicating the brewing has started in the selected brew strength. The coffeemaker warmer plate will keep your coffee hot for 2 hours and then automatically turn off. As a safety feature, your coffeemaker will NOT start again automatically the next day. If you want your coffee to brew at the same time the following day, simply add a new filter, coffee and water and set DELAY BREW, by repeating Steps 2 and 3 above. [. . . ] If you are unable to find a replacement, please visit us online at www. Repairs If your coffeemaker requires service, do not return it to the store where you purchased it. All repairs and replacements must be made by Sunbeam or an authorized Sunbeam Service Center. Or Canada, please call us at the following toll-free telephone numbers to find the location of the nearest authorized service center: U. [. . . ]