User manual MPC ELECTRONICS THE KIT

[. . . ] Pay particular attention to the "Important Warnings and Precautions" on Page 1. · The mount is designed to be installed using wall studs or supporting framework. The fasteners used to anchor the mount must be capable of supporting five times the total weight of the equipment. [. . . ] · The maximum weight to be installed on the Universal Pitch-Adjustable Wall Mount is 125 pounds (56. 7 Kg). Sony Electronics Inc. 8805-000087 1 Sony Drive Park Ridge, NJ 07656 201-930-1000 www. sony. com/displaysystems Installation Instructions Pitch-Adjustable Mount PLP91/D IMPORTANT WARNINGS AND PRECAUTIONS! WARNING: CAUTION: A WARNING alerts you to the possibility of serious injury or death if you do not follow the instructions. A CAUTION alerts you to the possibility of damage or destruction of equipment if you do not follow the corresponding instructions. · WARNING: Improper installation can result in serious personal injury!Make sure that the structural members can support a weight factor five times the total weight of the equipment. · WARNING: Be aware also of the potential for personal injury or damage to the unit if it is not adequately mounted. · WARNING: The installer is responsible for verifying that the wall to which the mount is anchored will safely support the combined load of all attached components or other equipment. · WARNING: Make sure the mount and brackets are correctly oriented. Place Nylon spacers over the mounting holes on the back of the screen. Mounting Button Attachment Attach Mounting Buttons Using These Holes Figure 3. Mounting Button Location 4 Installation Instructions Pitch-Adjustable Mount PLP91/D 3. Attach mounting brackets to the display using the M5 screws for 32" screen or M6 for the 42" and 50" screens (see Figure 4 and Figure 5). Nylon Spacer 6mm Nylon Spacer 6mm Nylon Spacer 5mm 42" Display 32" Display 50" Display Figure 4. Bracket Attachment Location 5 Installation Instructions Pitch-Adjustable Mount PLP91/D MOUNT THE DISPLAY Mount the display as follows: 1. Make sure no power is supplied to the display and the flag is in the lowered (open) position before attempting to mount the display. Make sure all four Q-buttons of the display engage all four slots in the mount. With the Q-buttons of the display fully engaged in the slots of the mount, secure the display on the mount by raising the flag all the way to their locked position. [. . . ] With the Q-buttons of the display fully engaged in the slots of the mount, secure the display on the mount by raising the flag all the way to their locked position. If the flag does not fully engage, remove the display and make sure the brackets are correctly installed. Security Lock May Be Installed 2. 3. Figure 6. Optional Security Loosen or tighten this bolt to adjust tilt tension or lock in place NOTE: A security lock may be installed through the hole in the locking flag for additional security (see Figure 6). [. . . ]