Detailed instructions for use are in the User's Guide.
[. . . ] DSR205
User Guide
This user guide is for use with DSR205 Digital Satellite Receivers
Publication #516581-001 Rev A
All Rights Reserved
General Instrument Corporation doing business as the Broadband Communications Sector of Motorola, Inc. San Diego, California 92121 Internet: http//www. mot. com
Copyright © 2004 Motorola, Inc. No part of this publication may be reproduced in any form or by any means or used to make any derivative work (such as translation, transformation or adaptation) without written permission from Motorola, Inc. Motorola reserves the right to revise this publication and to make changes in content from time to time without obligation on the part of Motorola to provide notification of such revision or change. [. . . ] If you have multiple receivers, you will have to change the address on each of them. Choose from following addresses: 0000, 0001, 0002, or 0003.
To program your remote control for each receiver, hold down the SAT key on the remote control until the light flashes. Once the light begins to flash enter the desired address.
Replacing the Remote Control Batteries
When the remote control batteries are worn out (discharged), the remote will stop working. Replace the batteries as soon as possible to retain your programmed codes. Once you remove the batteries from the compartment, you must replace them within two hours to retain your programmable features. Use only high quality, noncorrosive batteries designed for use in electronic equipment. To replace the batteries: Remove the cover by pressing down the back panel indentation and removing the panel off the remote control. Position each battery in the battery compartment so that the flat base (-) is against the spring and so that the raised contact (+) is against the terminal. Replace the cover.
"Remote Energy Saver"
If you misplace your remote (i. e. , it is stuck in your couch), and a key is inadvertently pressed, the remote will automatically turn itself off after three minutes.
DSR205 User Guide
15
2
TV Codes
ABI . . 1024, 1025, 1027, 1028, 1034, 1066, 1067, 1068
Using Your Remote
TV Codes (continued)
Majestic . . 1006, 1019, 1156, 1163, 1192, 1194
DSR205 User Guide
2
DVD Players
Aiwa . . 2088
18
Using Your Remote
VCR Recorders (continued)
Logik . . 2088 Matsushita 2054, 2114, 2137, 2138, 2139, 2154, 2158 Memorex . 2033, 2049, 2054, 2056, 2066, 2081, 2082 . 209121142130 215421612172 Realistic 20492054205620802081 208220842085 2088 . 20542056208720882158 Toshiba 20342035206720702084 208620902169 Totevision . . 203320622088
DSR205 User Guide
19
2
Cable Boxes
AT&T . 4034, 4041, 4043, 4044, 4079 Kenwood 4058, 4059, 4083, 4087, 4135, 4162, 4214 Koss . . 4205, 4206, 4228
DSR205 User Guide
21
2
Combination TV/VCRs, TV/DVD
Aiwa. . 4190
22
3
Watching TV
Once you become accustomed to the various controls and features, you will spend most of your television viewing time enjoying the programs made available through the satellite receiver. The features described in this section will be available to you when the remote control is set to SAT mode-- in other words, when you have pressed the SAT key and are viewing various programs.
How to Select Menu Options
As you use the many menus, you will be asked to select various options. When you see the word select, it is important that when you use the remote control, there are two ways to select a menu option:
2. If the options are numbered, simply press the number key for an option. [. . . ] Select option 2 and then select Mono, Stereo, or Surround.
·
44
Options
Installation Settings
Tune in Satellite Signal. This option allows you to see the strength of the signal your antenna is receiving. This option allows you to control up to four receivers in a centralized area with one or more remote controls. On the front panel of your receiver press the Menu button to bring up the Menu screen. [. . . ]