User manual MORPHY RICHARDS ULTRALIGHT CYCLONE VACUUM CLEANER

[. . . ] Use only genuine Morphy Richards spare parts and accessories Never over-extend the hose such that the cleaner is pulled over. If the cleaner is knocked over, switch off before attempting to upright. Never pick the cleaner up by the floor nozzle when connected to the mains, use the carrying handle. away from the floor nozzle whenever the cleaner is connected to the mains. [. . . ] · Never have the brushes set too low such that the cleaner is hard to push. Certain models only Floor nozzle height adjustment C Before using the cleaner the floor nozzle height must be set to the correct height. Choose the setting which most closely matches your floor surface, ie deep carpet pile, medium carpet pile, short carpet pile or hard floor. When using the attachments the cleaner must only be used in the upright position with the carpet height adjustment knob set to deep carpet. B D max min Use attachments E C DEEP CARPET HARD FLOOR Normal use Floors Clean under furniture Flat position 4 8537 Upright cyclone ib 12/05/2003 18:11 Page 5 Using attachments Follow previous steps 1-4 but set the carpet height adjustment knob to the deep carpet setting. 5 Remove the hose connector from the rear of the cleaner and push the required attachment firmly onto the end of the hose. · If additional length is required, attach one or both extension tubes between the hose and tool. IMPORTANT: Never over extend the hose such that the cleaner is pulled over. Cleaning the filters To maintain suction, the filters must be regularly taken out and cleaned. Failure to clean the filters will reduce the suction and will damage the motor if used for prolonged periods. IMPORTANT: Do not operate the cleaner without the filters in place. Circular pleated & foam filters G Emptying the dust canister F When the dust canister is full it should be emptied immediately. 1 Remove the front cover < by lifting the cover release lever ¤. 2 Lift-up the dust canister release Î and pull the canister away from the main body. 3 Hold the canister by the handle Ù over a dustbin and with your other hand press the dust release button Ò. Replace the front panel by aligning the bottom tabs with the slots in the body, then pressing in the top. Î ¤ IMPORTANT: The filters should be cleaned regularly to maintain the performance of the cleaner. 3 Lift up the pleated circular filter Ì and foam filter Ó beneath. The filters can be cleaned using the brush Û clipped inside G Ì Ó Û Ï F < Ò Ù 5 8537 Upright cyclone ib 12/05/2003 18:11 Page 6 the canister lid. The filters can be washed in warm water then left to air-dry naturally. Do not use detergents. only but must be totally dry before re-fitting. The canister has a safety inter-lock that prevents it from being fitted back into place if the filters have not been fitted correctly. Motor protection filter Central filter H 4 Lift the central canister filter out of the canister. 6 Re-assemble by replacing the central canister filter into the canister. [. . . ] Check the airways for blockages and clean the filters before restarting. Replacing the belt MN 6 If the belt has broken, ensure all pieces are removed. 9 Place one end of the new belt over the metal motor shaft pin and the other around the pulley end of the brush N. 10 Align brush end plates with their guide slots and push the brush bar down into place. Push the Helpline If you have any difficulty with your appliance, do not hesitate to call us. [. . . ]