User manual MORPHY RICHARDS TURBOSTEAM 40659

[. . . ] Never yank the cord to disconnect from the socket, instead, grasp plug and pull to disconnect. Children do not understand the dangers associated with operating electrical appliances. Close supervision is necessary when any appliance is used near children. With a bared flexible cord is hazardous if engaged into a live socket outlet. [. . . ] Textiles and clothes should carry ironing instructions, but if they don't, follow this fabric guide. Be sure to test the temperature by ironing the hem of the garment or similar area first. Tricel/Polyester Iron on wrong side If moisture required use damp cloth (not Acetate) Dry and spray Wool, Polyester mixtures e. Rayon/Linen Fabrics requiring this setting usually require steam pressing for heavy cotton, denim etc. The shot-of-steam can be used whilst dry ironing, providing there is water in the tank, and the temperature control is set within the steam range. Do not use shot-of-steam at temperatures below the steam range shown on the control dial. For optimum steam quality, do not operate the shot more than three times in succession. If the iron is left unattended in the horizontal position it will shut down after 30 seconds. If it is left in the vertical position it will shut down after 8 minutes. When this happens the two `power on' lights, located in the back cover will flash to show that the iron is in power-off mode. To reactivate the iron gently shake it until the `power on' lights stop flashing and remain on. The iron will then start to heat back up to the temperature it is set to. Hold the iron in a vertical position between 1cm and 2cm away from the item C. This feature is especially useful for removing creases from hanging clothes, curtains, wall hangings, etc. For optimum steam quality, do not operate the shot more than three times in succession. The life long anti-scale system reduces scale deposits and helps prolong the life of the iron. You can do this whilst dry ironing providing there is water in the tank. When using the water spray it may be necessary to push the button a few times to get the spray pump primed. Ensure that the variable steam control is set at the `O' position, lift up the fill cap and empty any remaining water out of the filling hole. Do not store in the box, but in an upright position, so that any drops of water remaining cannot leak out and discolour the soleplate. IMPORTANT: The flex can be damaged if wound too tightly around the iron after use. The iron must be cool before winding the flex and storing on its heel. [. . . ] Where the appliance has been used for hire purposes or non domestic use. Morphy Richards are not liable to carry out any type of servicing work, under the guarantee. the guarantee excludes consumables such as bags , filters and glass carafes. This guarantee does not confer any rights other than those expressly set out above and does not cover any claims for consequential loss or damage. [. . . ]