User manual MORPHY RICHARDS STAINLESS STEEL KETTLE

[. . . ] Always close the lid if applicable and always have the filter in place. Avoid contact with emitting steam when the water is boiling or just after it has switched off. Do not open the lid whilst the water is boiling · · Location · Always locate your appliance away from the edge of the worktop. · · Ensure that the appliance is used on a firm, flat surface. [. . . ] Do not stop to remove clothing, get medical help quickly. Other safety considerations · Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions or has been damaged in any manner. Contact Morphy Richards for advice. 3 KT43027MUK 20/6/07 09:16 Page 4 A / , , 3 Plug in and switch on at the wall socket. If you are using the kettle for the first time, pour away the boiled water and refill. Lift the kettle from the base unit by the handle ensuring you hold the kettle level. If the kettle has just switched off wait a minute or so before switching it back on again. If you do not put in enough water, or switch on the kettle when it is empty, the safety cut-out will switch off the power automatically. If this happens, refill and wait a few minutes for the element to cool, then use as normal. 4 , < ¤ 5 · · > 6 fi fl · Features / ¤ < > fi fl · , , , A · Lid Cool touch handle Water level indicator On/off switch 360º connector Cord storage Cordless base unit Concealed element Spout filter Spout Filter removal 1 2 Open the lid. To refit the filter, slide it into the side wall guides of the filter holder until it clicks into place. WARNING: Unless the filter is fitted correctly, the kettle lid may not close and lock securely. Using 1 Filling the kettle Wherever possible fill through the spout, as this helps to free the filter from limescale build-up. The integrated water level indicator allows you to easily see the amount of water in the kettle. Always ensure that the level of water in the kettle is filled to at least the minimum level shown on the water gauge. Should your kettle not have a water gauge, always ensure that the element is covered. Place the kettle on the base unit, ensuring the kettle locates on to the 360° connector. The 360° connector allows the kettle to be located at any position. - ideal for left and right handed users and for convenient positioning on the worktop. 3 · · Descaling IMPORTANT: As this kettle is fitted with a concealed element it must be descaled regularly. The frequency of descaling depends on usage and the hardness of the water in your area. Excessive scale can cause the kettle to switch off before boiling and may damage the element invalidating the warranty. It is essential that regular descaling takes place. · 2 · 4 KT43027MUK 20/6/07 09:16 Page 5 Remove hard scale using a proprietary descaling product suitable for stainless steel kettles. Alternatively use citric acid crystals (available from most pharmacies) as follows. 1 Fill the kettle 3/4 full, boil, then unplug the kettle (remove the cordless kettle from the base unit) and stand it in an empty sink or bowl. Add 50gm of citric acid crystals to the water gradually, then leave the kettle to stand. As soon as the effervescence subsides, empty the kettle and rinse it thoroughly with cold water. [. . . ] Where the appliance has been used for hire purposes or non domestic use. Morphy Richards are not liable to carry out any type of servicing work, under the guarantee. Plastic filters for all Morphy Richards kettles and coffee makers are not covered by the guarantee. This guarantee does not confer any rights other than those expressly set out above and does not cover any claims for consequential loss or damage. [. . . ]