User manual MORPHY RICHARDS SEMI-ELECTRONIC 40715

[. . . ] The socket should always be off before plugging or unplugging from the socket. Never yank the cord to disconnect from the socket, instead, grasp plug and pull to disconnect. The use of any electrical appliance requires the following common sense safety rules. Primarily there is danger of injury or death and secondly the danger of damage to the appliance. [. . . ] WARNING: When filling your iron with tap water always use the beaker provided. make sure the variable steam control / is set to the `0' symbol. The spray feature may be used provided there is water in the tank (see filling section). Do not use shot of steam at temperatures below the steam range shown on the control dial. Note: For optimum steam quality, do not operate the shot more than three times in succession. Hold the iron in a vertical position between 1cm and 2cm away from the item F. Press the shot of steam button ¤, this will create vertical steam. This feature is especially useful for removing creases from hanging clothes, curtains, wall hangings, etc. Note; For optimum steam quality, do not operate the shot more than three times in succession. You can do this whilst dry ironing providing there is water in the tank. When using the water spray it may be necessary to push the button a few times to get the spray pump primed. Your iron is fitted with a no drip system which is designed to prevent water escaping from the soleplate when the iron is too cold. During use, the no drip system may emit a loud click, particularly during heat-up or whilst cooling down. This is perfectly normal and indicates that the system is functioning correctly. Fill the iron with water as described in `Filling', page 4 and insert the plug into the electrical socket. The steam output can be varied from low to high by turning the variable steam control D. When using the iron at the bottom of the steam range, the steam output should be adjusted to the low setting. The steam facility should only be used on garments which are suitable for ironing at 2, 3 dot and MAX setting. Your iron is fitted with the auto shutoff function it will automatically shut down after a set period. If the iron is left unattended in the horizontal position it will shut down after 30 seconds on certain models and after 1 minute on models with illuminated tanks. If it is left in the vertical position it will shut down after 8 minutes. To reactivate the iron gently shake it and wait for the iron to heat-up as normal. [. . . ] This warranty is in addition and does not affect your statutory rights. In the unlikely event of any appliance proving to be faulty, securely pack and return the item to the place of purchase accompanied by the original receipt or invoice. Agrafez votre ticket de caisse à cette notice d'utilisation; vous pourrez ainsi l'avoir sous la main ultérieurement. Se till att strykjärnet inte är anslutet, ställ sedan väljaren för ånga till torrstrykning / till positionen "0" innan vatten fylls på. [. . . ]