User manual MORPHY RICHARDS PUMP ESPRESSO COFFEE MAKER 47507

[. . . ] Do not use abrasive cleaners on the outside of the coffee maker, they may scratch the surface. Do not use the coffee maker for anything other than its intended purpose. The use of any electrical appliance requires the following common sense safety rules. Primarily there is danger of injury or death and secondly the danger of damage to the appliance. [. . . ] Note: If any part of the pod, including the flap, is outside the filter holder the sealing system will not function properly. This will affect the functioning of the machine and the coffee quality. 4 Place the filter holder on the brewing head fi and position the handle so it points left. Ensure the filter holder is flat against the brewing head and turn the handle towards the right I as far as it will go. place a pre-heated cup below the outlet holes of the filter holder J. Note: One coffee pod has the measured amount of coffee for one single espresso. When the coffee is at the correct temperature the sign will be displayed. Once the cup is filled to the desired level, move the lever back to the off position. Water will still filter through for approximately 8 seconds after the lever has been moved to the off position. Carefully remove the filter holder by turning the handle slowly to the left. To remove the pod from the filter, push the filter lock fl forward over the edge of the filter and turn the filter holder upside down, gently tap out the pod L. IMPORTANT: For the froth enhancing attachment to work you must ensure that it is pushed firmly onto the steam nozzle. swing the steam nozzle with the froth attachment to the side of the machine. Press the steam button <, when the unit is ready to make steam the sign shows. This sign will flash on the display until the machine reaches the correct temperature to make steam when it becomes fixed. Note: For best results we recommend to use refrigerated milk and a stainless steel jug that is well chilled. Hold the jug under the steam nozzle so that the head of the froth attachment is immersed in milk and push the lever up to the steam setting Q. IMPORTANT: Do not allow the tip of the nozzle to touch the bottom of the jug because this could obstruct the passage of steam. 10 Once the sign shows, your machine is ready to make the next espresso. Note: It is normal for the symbols on the display to cycle on and off during the water heat up process. Once the froth has been produced push the lever down to the off position and remove the jug. Note: It is normal to hear a pumping sound when switching from steam mode to coffee mode or hot water mode. [. . . ] This guarantee is offered as an additional benefit and does not affect your statutory rights as a consumer. Agrafez votre ticket de caisse à cette notice d'utilisation; vous pourrez ainsi l'avoir sous la main ultérieurement. Primärt finns risk för personskada och/eller dödsfall och sekundärt finns risk att hushållsapparaten skadas. När du har fyllt kopparna till önskad nivå flyttar du spaken till avstängningsläget. [. . . ]