User manual MORPHY RICHARDS PRECISE STEAM IRON REV 3

[. . . ] To prevent damage to the textile being ironed, follow the temperature guide carefully. When ironing is complete, turn off the steam selector switch, remove the plug from the socket, empty any remaining water from the tank, and allow to cool before storage. If you drop or severely knock your iron this could cause internal damage even if the outside appears alright. It is recommended that you use up one beaker of water by operating your iron's steam and shot of steam functions before ironing any clothes as some dripping may occur while your irons steam system is activated. · The socket should always be off before plugging or unplugging from the socket. [. . . ] In hard water areas the use of distilled or demineralised water is recommended. WARNING: Never use battery topping up fluid or water containing any substances like starch, or sugar, or defrosted water from a refrigerator. WARNING: When filling your iron with tap water always use the beaker provided. Never fill directly under the tap. FEATURES OF YOUR IRON Temperature indicator light The indicator light fl shows that the iron is warming up. When the required temperature is reached the light will go out and will cycle on-off during operation. 2 Dry ironing You can use your iron as a dry iron only. Make sure the steam to dry iron selector switch / is set to the symbol. The spray feature may be used provided there is water in the tank (see filling section). You do not need to put any water in the tank when dry ironing only. B Spray C Press the spray button > and aim the spray of water at stubborn creases. You can do this whilst dry ironing providing there is water in the tank. When using the water spray it may be necessary to push the button a few times to get the spray pump primed. TEMPERATURE CONTROL B C Plug in the iron and switch on. Set the temperature control dial ¤ to the temperature required, but don't start ironing immediately. If you wait a few minutes, the iron will stabilise at the required setting. Your Morphy Richards iron is fitted with an indicator light fl which will go on and off while you are ironing. This is perfectly normal as it shows that the iron is maintaining the heat setting you have chosen. It is always a good idea to begin with cool fabrics and work up to higher settings. An iron heats up quicker than it cools down so you'll save time and electricity. Automatic variable steam B Fill the iron with water as described in the filling section, and insert the plug into the electrical socket. Select the temperature required by turning the temperature control dial ¤ to the desired setting. The amount of steam required is automatically selected and is displayed in window <. Press the shot of steam button fi to obtain a burst of extra steam for ironing out creases in www. morphyrichards. com 5 40725 rev3 14/8/06 14:03 Page 6 heavy material such as denim etc. The shot of steam can be used whilst dry ironing, providing there is water in the tank, and the temperature control is set within the steam range. Do not use shot of steam at temperatures below the steam range (2-DOT) shown on the control dial. Note: For optimum steam quality, do not operate the shot more than three times in succession. this occurs, the indicator light will flash and a beep will be heard. [. . . ] Plastic filters for all Morphy Richards kettles and coffee makers are not covered by the guarantee. This guarantee does not confer any rights other than those expressly set out above and does not cover any claims for consequential loss or damage. This guarantee is offered as an additional benefit and does not affect your statutory rights as a consumer. 5 6 EXCLUSIONS Morphy Richards shall not be liable to replace or repair the goods under the terms of the guarantee where: The fault has been caused or is attributable to accidental use, misuse, negligent use or used contrary to the manufacturers recommendations or where the fault has been caused by power surges or damage caused in transit. The appliance has been used on a voltage supply other than that stamped on the products. [. . . ]