User manual MORPHY RICHARDS PERFORMAIR CYCLONIC VACUUM CLEANER 71062

[. . . ] Young children should be supervised to ensure that they do not play with the appliance or stumble over the power cord. The plug must be removed from the wall socket before cleaning or maintaining the appliance. Never pick up inflammable or poisonous liquids such as petrol, copier toner or other volatile substances. Check that the voltage on the rating plate of your appliance corresponds with your house electricity supply which must be A. [. . . ] Using the large turbo nozzle (certain models only) attach the large turbo nozzle to the telescopic tubes. This nozzle is ideal for carpet and especially effective at removing pet hair. Combination floor nozzle Large turbo nozzle Small turbo nozzle Hard floor nozzle Crevice tool Upholstery Hair and nozzle Stair tool with clip on-brush With brushes down With brushes down For example, maximum suction can be used for cleaning carpets, hard floors etc. Suction can also be controlled using the airflow regulator on the hose handle. To obtain the best results from your cleaner empty the dust canister regularly, otherwise the airflow and cleaning power will be reduced. 1 Everytime the dust canister is emptied, turn the yellow dial (a minimum of 5 revolutions) prior to pressing the dust canister release button (this will agitate the fine dust between the filter pleats and restore the air flow) Remove the dust canister from the product by pressing the dust canister release button < Lift up the lid and remove the canister from the product, pulling the dust canister away from the product C. Holding the dust canister over a dustbin press the dust release button as shown D, the bottom of the dust container will drop down to release the dirt. WARNING: When using the cable rewind, always hold the plug as the cable will rewind quickly. Close the bottom of the dust canister by pressing the base upwards until it clicks into place. The dust container may not lock back onto the machine unless the filter is fitted correctly Press the catch and pull the exhaust grille away F. Pull the bottom of the filter outwards so the top of the filter unhooks from the filter recess. foam filters may be washed (in cool water) , thoroughly air-dried and refitted. The pleated filters used on the Allergy models cannot be washed and should be replaced every 6 months or sooner depending on use. IMPORTANT: To re-fit the filters, first hook the top of the filter into the filter recess then push the bottom of the filter into location G. Note: If the filter is not correctly hooked in the exhaust filter grille will not close. After fitting the filter, re-fit the exhaust filter grille by hooking the bottom of the grille in first and then pushing the top close until it clicks fully closed. IMPORTANT: All filters should be checked regularly for signs of damage, preferably after each cleaning task. 1 Place the container inside the plastic bag, releasing the container with one hand whilst holding the top of the bag closed with the other, leave the dust to settle for a few seconds before carefully removing the empty canister. Use the filter cleaning brush to remove any fluff from the outside of the mesh filter or gently tap. Both the mesh and pleated filters may be washed (in cool water only) but must be thoroughly air dried before refitting. To re-assemble, locate the pleated filter into the lid then secure into place with the mesh filter by rotating the mesh filter anti-clockwise. Fit the lid with filter assembly onto the canister then rotate clockwise until it locks into place. [. . . ] 6 Subject to the exclusions set out below (see Exclusions) the faulty appliance will then be repaired or replaced and dispatched usually within 7 working days of receipt. This guarantee is offered as an additional benefit and does not affect your statutory rights as a consumer. This appliance is guaranteed for 2 years against faulty material, components and workmanship. This warranty is in addition and does not affect your statutory rights. [. . . ]