User manual MORPHY RICHARDS PERFORMAIR CYCLONIC VACUUM CLEANER

[. . . ] If the socket outlets in your home are not suitable for the plug supplied with this appliance the plug should be removed and the appropriate one fitted. If you cut off the plug and let go of the cable it will rewind into the machine therefore you must pull out a length of cable and secure it before cutting the plug off and refitting a new one. WARNING: The plug removed from the mains lead, if severed, must be destroyed as a plug with a bared flexible cord is hazardous if engaged into a live socket outlet. Where used, should the fuse in the 13 amp plug require changing a 13 amp BS1362 fuse must be fitted. [. . . ] For example, maximum suction can be used for cleaning carpets, hard floors etc. Suction can also be controlled using the airflow regulator on the hose handle. To obtain the best results from your cleaner empty the dust canister regularly, otherwise the airflow and cleaning power will be reduced. 1 Everytime the dust canister is emptied, turn the yellow dial (a minimum of 5 revolutions) prior to pressing the dust canister release button (this will agitate the fine dust between the filter pleats and restore the air flow) C 2 Remove the dust canister from the product by pressing the dust canister release button < Lift up the lid and remove the canister from the product, pulling the dust canister away from the product C. Holding the dust canister over a dustbin press the dust release button as shown D, the bottom of the dust container will drop down to release the dirt. Close the bottom of the dust canister by pressing the base upwards until it clicks into place. 5 Both the mesh and pleated filters may be washed (in cool water only) but must be thoroughly air dried before refitting. A spare filter is provided to use whilst cleaning and drying the original fitted filter. To re-assemble, locate the pleated filter into the lid then secure into place with the mesh filter by rotating the mesh filter clockwise. Fit the lid with filter assembly onto the canister then rotate clockwise until it locks into place. Note: If the filter is not correctly hooked in the exhaust filter grille will not close. After fitting the filter, re-fit the exhaust filter grille by hooking the bottom of the grille in first and then pushing the top close until it clicks fully closed. IMPORTANT: All filters should be checked regularly for signs of damage, preferably after each cleaning task. If you have any difficulty with your appliance, do not hesitate to call us. We are more likely to be able to help than the store from where you bought it. Please have the following information ready to enable our staff to deal with your query quickly. 2 1 Place the container inside the plastic bag, releasing the container with one hand whilst holding the top of the bag closed with the other, leave the dust to settle for a few seconds before carefully removing the empty canister. please quote the following information if the product develops a fault. After emptying the dust canister and removing the filters (as described in points 1-4 above) open the clear packaging and remove the vacuum freshener. When finished you can store the tubes and accessories by locating the tube storage clip into the parking slot on the side of the cleaner as shown H. If this happens, switch the cleaner off, unplug from the power supply and leave the cleaner to cool for at least 30 minutes. Check the airways for blockages, empty dust canister and clean the filters before restarting. [. . . ] This guarantee is offered as an additional benefit and does not affect your statutory rights as a consumer. 1 The fault has been caused or is attributable to accidental use, misuse, negligent use or used contrary to the manufacturers recommendations or where the fault has been caused by power surges or damage caused in transit. The appliance has been used on a voltage supply other than that stamped on the products. Repairs have been attempted by persons other than our service staff (or authorised dealer). [. . . ]