User manual MORPHY RICHARDS MISTER CAPPUCINO EXPRESSO AND FILTER COFFEE MAKER

[. . . ] Mister Cappuccino Espresso and filter coffee maker (with heated milk frother) Please read and keep these instructions Getting the best from your new coffee maker. The pressure cap must be slowly removed before unlocking the filter holder. Safety first Caution must be used when handling hot water, coffee or steam. Run water through your machine before first use It is important to run water through your coffee maker in order to rinse the machine. [. . . ] the jug is marked with the water levels for 2 cups (minimum) , 4 cups and 6 cups (maximum). Always switch the machine off and remove the plug from the socket before filling the water tank. Care should be taken to ensure that the correct quantity of water is placed in the tank, as the machine always uses all the water. Place the washable metal filter > into the filter holder fl and add the desired quantity of coffee to the filter using the measuring spoon provided. Special marks on the inside of the filter show the correct levels for 2, 4 and 6 cups of coffee lightly compress the coffee down. Position the filter holder underneath the water outlet , , push it upwards and turn it to the right into the locked position to fix it onto your coffee machine C. 6 Your machine is fitted with a strength selector < which allows you to make LIGHT to STRONG coffee. Set the strength selector mid way between LIGHT and STRONG for MEDIUM strength coffee. Place your glass jug with the lid on the drip tray and · The coffee will start to flow from the filter holder spout after about 2 or 3 minutes. Wait until all the water from the water tank has flowed into your glass jug and the green light glows. When the filtering process is complete remove the glass jug from your coffee maker and pour the coffee into your cups. 11 To remove the used coffee grounds, remove the filter holder by turning the handle to the left until you find that the filter holder drops down. NOTE: Due to the amount of steam lost through the process, the coffee produced will be less than the water put in. This is accounted for in the amount to put in 1 Remove the cowl directly after use and rinse in cold water. It is recommended that you clean the blade immediately after use, as dried milk can be difficult to remove. 2 If further cleaning is required the propeller and shaft can be removed. To replace, insert the stem of the milk frother blade into the mounting hole on the unit and screw into place. There may be some splash back of milk on the underside of the frothing unit. Switch the unit off then simply wipe this area clean with a damp cloth. It is advised to start heating your milk ready for frothing several minutes before making coffee to ensure milk is hot. 1 Fill the stainless steel milk jug provided with the required amount of milk. place the jug on the hot plate and switch on , the orange light will glow. [. . . ] Do not use a cloth as any residue or lint left behind may clog the coffee maker. Wash the milk frother blade, milk frother attachment, milk frother jug, drip tray metal plate, drip tray, drip tray plate, glass jug, lid, filter, filter holder and stainless steel milk jug in warm soapy water. Refit filter, filter holder , milk frother blade and milk frother attachment. Unplug The coffee maker, slowly remove the pressure cap and allow to cool. [. . . ]