User manual MORPHY RICHARDS JET STREAM ELITE PRO

[. . . ] This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience or knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. · Always disconnect the steam generator from the electrical supply when cleaning or when not in use. Do not operate the steam generator with a damaged cord or if the iron has been dropped or if there are visible signs of damage or if it is leaking. To avoid the risk of electric shock, do not disassemble the iron, but telephone Morphy Richards for advice. Incorrect reassembly can cause a risk of electric shock when the iron is used. [. . . ] When ironing with the temperature set at 2-dot setting, the steam output should be set at the lower end of the steam range. If they don't, you should follow the fabric guide on page 3, but be sure to test the temperature by ironing the hem of the garment or similar area first. If you turn the control dial down from a hot setting to a cooler setting, wait until the iron temperature has stabilised before you continue ironing. 3 2 A 4 Steam ironing 1 Connect the appliance to a suitable mains outlet. ALL MODELS After a few minutes, the light changes to green - indicating the boiler is ready to generate steam. Check the iron temperature indicator light ¤ has switched off, indicating the iron is ready to use. MODELS WITH VARIABLE STEAM 42288, 42297, 42298 & 42299 This model automatically selects the middle steam setting as the default setting. To select a different steam setting, press the steam button Î to select the desired steam level. 2 Turn the temperature dial > on the iron in a clockwise direction, select dot-1, dot-2 or dot-3 according to the recommendation of the garment label. The iron's temperature indicator light ¤ goes off when the required temperature is reached. B FILLING 1 Place the steam generator on a stable ironing board or table, with the iron resting on it's stand. Release the detachable water tank by operating the tank release knob , , . Never use battery topping up fluid or water containing any substances like starch or sugar, or defrosted water from a refrigerator. 5 Re-position the water tank on the base unit and push securely into place. Please make sure the tank is secure B. 2 3 4 3 7 7 42288 rev4 14/3/08 11:14 Page 8 4 Depress the steam button / for 1 minute to clear the system of air (first time use only). Note: If you press the steam button before the steam generator reaches it's required temperature, a warning double beep will sound. Depress the power switch Á to turn off the base unit when ironing is complete. 2 42288, 42297, 42298 & 42299: Press the steam switch Î 2 times until all three steam level indicator lights go off (steam off mode). Turn the temperature dial > on the iron in a clockwise direction, select dot-1, dot-2, or dot-3 according to the recommendation of the garment label. The temperature indicator light ¤ glows on the iron, indicating that it is switched on. When the required temperature is reached, the temperature indicator light on the iron goes off. It is always a good idea to begin with `cool' fabrics and work up to higher settings. Remove the anti-scale cartridge which is situated behind the tank, and replace the cartridge, making sure the replacement unit is pushed firmly in position. The `calc' light  will flash, accompanied by a beep sound. [. . . ] Morphy Richards are not liable to carry out any type of servicing work, under the guarantee. Plastic filters for all Morphy Richards kettles and coffee makers are not covered by the guarantee. This guarantee does not confer any rights other than those expressly set out above and does not cover any claims for consequential loss or damage. This guarantee is offered as an additional benefit and does not affect your statutory rights as a consumer. [. . . ]