User manual MORPHY RICHARDS ILLUMA GLASS KETTLE REV 1

[. . . ] · Do not fill above the MAX mark, otherwise boiling water may be ejected. · Do not hold the switch in the on position or tamper with the switch to fix it in the on position as this may cause damage to the switch-off mechanism. · Allow to cool before putting on or taking off parts and before cleaning. Location · Always locate your kettle away from the edge of the worktop. · WARNING: Do not place the kettle onto a metal tray or metal surface whilst in use. Children · Children do not understand the dangers associated with operating electrical appliances. [. . . ] · IMPORTANT : When filling from a tap, care must be taken to avoid striking the glass body on the tap. · Always ensure that the level of water in the kettle is filled to at least the minimum level shown on the water level indicator. · Boil only as much water as you need as this saves electricity. 2 Place the kettle on the base unit, ensuring the kettle locates on to the 360° connector. · The 360° connector allows the kettle to be located at any position. - ideal for left and right handed users and for convenient positioning on worktop. · If you are using the kettle for the first time, pour away the boiled water and refill. 6 Lift the kettle from the base unit by the handle ensuring you hold the kettle level. If the kettle has just switched off wait a minute or so before switching it back on again. · If you do not put in enough water, or switch on the kettle when it is empty, the safety cut-out will switch off the power automatically. If this happens, refill and wait a few minutes for the element to cool, then use as normal. Filter removal 1 Open the lid using the release button ¤. 3 To refit the filter, slide it into the side guides of the filter holder until it clicks into place. WARNING: Unless the filter is fitted correctly, the kettle lid may not close and the kettle may not switch off after boiling. 4 43121 rev 1 11/4/05 10:34 AM Page 5 Descaling IMPORTANT: As this kettle is fitted with a concealed element it must be descaled regularly. Frequency of descaling depends on usage and the hardness of the water in your area. Excessive scale can cause the kettle to switch off before boiling and may damage the element invalidating the warranty. Remove hard scale using a proprietary descaling product suitable for glass kettles. We recommend Oust All Purpose Descaler (please follow the instructions carefully) which may be purchased from our Helpline or from your local retailer. Cleaning WARNING: Always disconnect the plug from the mains and allow the kettle to cool before cleaning. IMPORTANT: Do not use abrasive cleaners on the outside of the kettle which may scratch the surface. Helpline If you have any difficulty with your appliance, do not hesitate to call us. We're more likely to be able to help than the store from where you bought it. Please have the following information ready to enable our staff to deal with your query quickly: · Name of the product · Model number as shown on the underside of the appliance. Alternatively use citric acid crystals (available from most pharmacies) as follows. 1 Fill the kettle 3/4 full, boil, then unplug the kettle (remove the cordless kettle from the base unit) and stand it in an empty sink or bowl. 2 Add 50gm of citric acid crystals to the water gradually, then leave the kettle to stand. [. . . ] 3 Repairs have been attempted by persons other than our service staff (or authorised dealer). 4 Where the appliance has been used for hire purposes or non domestic use. 5 Morphy Richards are not liable to carry out any type of servicing work, under the guarantee. 6 Plastic filters for all Morphy Richards kettles and coffee makers are not covered by the guarantee. [. . . ]