User manual MORPHY RICHARDS IB73340

[. . . ] Never pick the cleaner up by the floor nozzle when connected to the mains, use the carrying handle. away from the floor nozzle whenever the cleaner is connected to the mains. Disconnect from the mains supply before attempting to clear blockages, clear the brush or replace the belt. Electrical requirements Check that the voltage on the rating plate of your appliance corresponds with your house electricity supply which must be A. C. If the socket outlets in your home are not suitable for the plug supplied with this appliance, the plug should be removed and the appropriate one fitted. [. . . ] deep carpet pile, medium carpet pile, short carpet pile or hard floor. · When using the attachments the cleaner must only be used in an upright position with the carpet height adjustment knob set to DEEP CARPET. Note: The height adjustment only comes into effect when the handle is released by the handle release pedal Â. Using attachments Follow steps 1-4 above but set the carpet height adjustment knob to the deep carpet setting. Lift the hose ¤ from the top handle hook and push the required attachment onto the end of the hose. · Push the required attachment firmly onto the end of the hose. · If additional length is required, attach one or both extension tubes between the hose and tool. · IMPORTANT: Always fix the hose clip È to the main body slot Ë when using the hose and tools. · Never over extend the hose such that the cleaner is pulled over. · Turning the cleaner sideways helps prevent the cleaner being pulled along by the stretch hose. B C DEEP CARPET TOOLS HARD FLOOR MEDIUM CARPET 4 73340 Rev 1 4/3/05 10:29 AM Page 5 Dust bag indicator When the cleaner is switched on, if the dust bag condition indicator is continuously showing red (or if the suction is reduced) the bag must be replaced and the filters cleaned. If it is still showing red after emptying the dust bag and cleaning the filters, check to see if the hose is blocked. 6 Once the new dust bag is in place, replace the front panel by aligning the bottom locking tabs with the slots in the body, close cover slowly allowing the front panel to snap in place. The latch will self lock. Cleaning the pre-motor filter E Changing the dust bag D 1 Unplug the power cable from the socket. 3 Remove the old dustbag by holding the cardboard tab and pull towards you. Remove carefully to avoid dust/dirt spilling from the dust bag and dispose. Holding the cardboard tab, push the bag over the opening of the dirt discharge tube until it is seated against the rear of the enclosure. 5 The front panel will not close unless the dust bag is correctly fitted due to the safety bag interlock. Í Always check and if necessary clean the pre-motor filter every time your change the dust bag. Everytime a new bag is fitted, the filter should be taken out and cleaned. Failure to clean the filter will reduce suction and will damage the motor if used for prolonged periods. 5 Replace front cover. Í D E 5 73340 Rev 1 4/3/05 10:29 AM Page 6 Replacing the HEPA Changing the belt exhaust filter F If the brush bar stops rotating it is likely The HEPA exhaust filter should be replaced every 6 months. · Replacement filters can be purchased from our replacement parts helpline. that the drive belt has snapped (usually because the brush has been stalled). [. . . ] 16 Replace the top cover, hooking it in at the front first and by pressing the handle release pedal to allow the rear to correctly locate K. 17 Turn the cleaner face down and re-fit and tighten the four fixing screws, do not overtighten. 18 Return the cleaner to its correct working position before re-testing. ÌJ Ó I Î K Ï 7 73340 Rev 1 4/3/05 10:29 AM Page 8 Your two-year guarantee · It is important to retain the retailers receipt as proof of purchase. Please quote the following information if the product develops a fault. [. . . ]