User manual MORPHY RICHARDS IB73300

[. . . ] Never pick the cleaner up by the floor nozzle when connected to the mains, use the carrying handle. away from the floor nozzle whenever the cleaner is connected to the mains. Disconnect from the mains supply before attempting to clear blockages, clear the brush or replace the belt. Electrical requirements Check that the voltage on the rating plate of your appliance corresponds with your house electricity supply which must be A. C. If the socket outlets in your home are not suitable for the plug supplied with this appliance, the plug should be removed and the appropriate one fitted. [. . . ] 5 Remove the hose connector from the rear of the cleaner and push the required attachment firmly onto the end of the hose. · If additional length is required, attach one or both extension tubes between the hose and tool. IMPORTANT: Never over extend the hose such that the cleaner is pulled over. B Use attachments E C Use DEEP CARPET HARD FLOOR Clean under furniture Flat position 4 8407 Upright ib 4 03/12/2002 1:18 PM Page 5 Dust bag condition When the cleaner is switched on, if the dust bag condition indicator is continuously showing red (or if the suction is reduced) the bag must be replaced and the filters cleaned. If it is still showing red after emptying the dust bag and cleaning the filters, check to see if the hose is blocked. Changing the filters F Changing the dust bag E 1 Unplug power cable from wall socket. 3 Remove the old dust bag by holding the cardboard tab and pull towards you. Remove carefully to avoid dust/dirt spilling from dust bag and dispose. Holding the cardboard tab, push the bag over the opening of the dirt discharge tube until it is seated against the rear of the enclosure. 5 The front panel will not close unless the dustbag is correctly fitted due to the safety bag interlock. Always check the pre-motor and post motor filters every time you change the dust bag. 6 Once the new dust bag is in place, replace the front panel by aligning the bottom locking tabs with the slots in the body, close cover slowly allowing the front panel to snap in place. The latch will self lock. Everytime a new bag is fitted, the filters should be taken out and cleaned. Failure to clean the filters will reduce the suction and will damage the motor if used for prolonged periods. 2 The pre-motor filter is located underneath the bag and the exhaust filter is below facing forward. To remove the exhaust motor filter, pull the locking tab on the right and it will snap out. 3 Remove the filters from their holders by unclipping and shake vigorously over a dustbin. 4 Replace front cover. E Î F 5 8407 Upright ib 4 03/12/2002 1:18 PM Page 6 Changing the brush belt If the power brush stops rotating it is likely that the drive belt has snapped (usually because the brush has been stalled). Replacement belts can be obtained from Morphy Richards or a Service Agent. 3 Use a cross-head screwdriver to remove the two screws from the front bottom and the central screw under the height adjustment mechanism G. 5 Remove the two screws at the rear and lift the rear of the cover off over the handle release button and unclip the cover from the front of the floor nozzle H. 6 If the belt has broken, remove any loose pieces before replacing. 7 Lift the belt cover Ï off. [. . . ] 5 Morphy Richards are not liable to carry out any type of servicing work, under the guarantee. 6 Consumables such as bags, filters and belt are not covered by the guarantee. All Morphy Richards Products are individually tested before leaving the factory. In the unlikely event of any appliance proving to be faulty within 28 days of purchase it should be returned to the place of purchase for it to be replaced. If the fault develops after 28 days and within 24 months of original purchase, you should contact the helpline number quoting model number and serial number on the product, or write to Morphy Richards at the address shown. [. . . ]