User manual MORPHY RICHARDS IB70312

[. . . ] · If the electrical cable becomes damaged the complete cable assembly must be replaced. Do not attempt this task yourself, contact us using the helpline number. Electrical requirements Check that the voltage on the rating plate of your appliance corresponds with your house electricity supply which must be A. C. If the socket outlets in your home are not suitable for the plug supplied with this appliance, the plug should be removed and the appropriate one fitted. If you cut off the plug and let go of the cable it will rewind into the machine. [. . . ] Closed: full suction Open: reduced suction Recommended settings Alter the power setting to suit surface. Power setting AX M MI N Application Curtains and delicate fabrics AX M MI N Textiles and upholstery AX M MI N Floor coverings such as rugs or economy setting for carpets AX M MI N Carpets or hard floor coverings 5 70312 Rev 2 15/10/04 11:14 AM Page 6 Tube standby During short breaks in cleaning the tubes can be held in an upright, `standby' position , whilst you move furniture for instance. IMPORTANT: Ensure that the appliance is never left unattended whilst it is switched on. Switching off Switch off the appliance. Remove the plug from the mains supply and rewind the power cable using the cable rewind switch fl. WARNING: When using the cable rewind, always hold the plug as the cable will rewind quickly. Storage Tube park The vacuum cleaner can be stored in an upright position. Rotate the floor nozzle until the lug on the back of it can be fitted into the tube park slot on the base of the appliance ·. 6 70312 Rev 2 15/10/04 11:14 AM Page 7 Changing the dustbag If suction power is reduced or if the `dust bag full' indicator < is permanently fully red, the dust bag needs changing. To access the dust bag, press the dust compartment release lever , , to open the cover. 1 Pull the tab on the dust bag to one side so that the opening is hygienically sealed. 4 Dispose of the bag with your household waste. 5 Insert a new dust bag in the holder. IMPORTANT: The dust bag compartment cover can only be closed once a dust bag has been correctly fitted. 7 70312 Rev 2 15/10/04 11:14 AM Page 8 Changing/cleaning the motor protection filter The motor protection is accessible from the dust compartment only when the dust bag has been removed first. IMPORTANT: Never use the appliance without the motor protection filter installed, otherwise damage to the motor may occur which would not be covered by the guarantee. 5 Close the filter holder and place back into position before removed. It is recommended that this filter is cleaned everytime the dustbag is changed, and is replaced every 5 dustbag changes. 8 70312 Rev 2 15/10/04 11:14 AM Page 9 Changing/cleaning the exhaust air filter The exhaust air filter should be cleaned by shaking every time the dustbag is changed. The exhaust filter is non-washable. Cleaning and maintenance Unplug from the mains before cleaning. The vacuum cleaner, especially the dust compartment and all accessories can be cleaned using a damp cloth or a nonabrasive domestic cleaner and wiped dry. To keep the underside of the floor nozzle clean, vacuum it at regular intervals using the crevice tool. Stair lock This unique system assists with stair cleaning. The stairhook, found underneath, is lifted out as shown and locked onto the stairs. In addition, the rear wheels automatically lock in position as further security. IMPORTANT: When cleaning on stairs, for convenience and safety, work from the bottom to the top with the desired accessory connected directly onto the hose handle. [. . . ] Therefore it is vital to retain your original receipt or invoice to indicate the date of initial purchase. To qualify for the two-year guarantee the appliance must have been used according to the manufacturers instructions. Morphy richards shall not be liable to replace or repair the goods under the terms of the Guarantee where: 1 The fault has been caused or is attributable to accidental use, mis-use, negligent use or used contrary to the manufacturers recommendations or where the fault has been caused by power surges or damage caused in transit. 2 The appliance has been used on a voltage supply other than that stamped on the products. [. . . ]