User manual MORPHY RICHARDS IB47507

[. . . ] · WARNING: Do not immerse the coffee maker itself in water and always ensure the electrical connections are kept dry. · Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions or has been damaged in any manner. · The use of attachments or tools not recommended or sold by Morphy Richards may cause fire, electric shock or injury. · Do not use abrasive cleaners on the outside of the coffee maker, they may scratch the surface. [. . . ] J 12Once the sign shows, your machine is ready to make the next espresso. Note: It is normal for the symbols on the display to cycle on and off during the water heat up process. Using with the coffee pods 1 Select the pod filter Ï and place in the filter holder . M 4 Place the filter holder on the brewing head fi and position the handle so it points left. Ensure the filter holder is flat against the brewing head and turn the handle towards the right N as far as it will go. O Note: One coffee pod has the measured amount of coffee for one single espresso. When the coffee is at the correct temperature the sign will be displayed. 6 Move the lever down to the coffee setting. 7 Once the cup is nearly filled to the desired level, move the lever back to the off position. Water will filter through for approximately 8 seconds after the machine has been turned off. 9 To remove the pod from the filter, push the filter lock fl forward over the edge of the filter and turn the filter holder upside down. P 10Once the sign shows, your machine is ready to make the next espresso. Note: It is normal for the symbols on the display to cycle on and off during the water heat up process. I J M N K L O P 5 47507 Rev 1 5/4/05 4:02 PM Page 6 Steam function The froth attachment makes it easy to produce frothy milk for cappuccino. 2 Attach the froth attachment Ë to the end of the steam nozzle È. Q IMPORTANT: For the froth enhancing attachment to work you must ensure that it is pushed firmly onto the steam nozzle. 4 Swing the steam nozzle with the froth attachment to the side of the machine. 5 Press the steam button < when the unit is ready to make steam, the sign shows. This sign will flash on the display until the machine reaches the correct temperature to make steam when it becomes fixed. Note: For best results we recommend to use refrigerated milk and a stainless steel jug that is well chilled. 7 Hold the jug under the steam nozzle so that the head of the froth attachment is immersed in milk and push the lever up to the steam setting. IMPORTANT: Do not allow the tip of the nozzle to touch the bottom of the jug because this could obstruct the passage of steam. 8 Once the froth has been produced push the lever down to the off position and remove the jug. Note: It is normal to hear a pumping sound when switching from steam mode to coffee mode or hot water mode. The milk is ready as soon as it forms a soft, thick layer of foam on the top. If the milk starts to make large popping bubbles, you have boiled the milk and it will therefore not froth. [. . . ] 3 Repairs have been attempted by persons other than our service staff (or authorised dealer). 4 Where the appliance has been used for hire purposes or non domestic use. 5 Morphy Richards are not liable to carry out any type of servicing work, under the guarantee. 6 Plastic filters for all Morphy Richards kettles and coffee makers are not covered by the guarantee. [. . . ]