User manual MORPHY RICHARDS IB42370

[. . . ] · Trailing cords are a hazard, keep them out of the way to prevent accidents. Other safety considerations · Use the steam generator only for its intended use. · Always disconnect the steam generator from the electrical supply when cleaning or when not in use. · Do not operate the steam generator with a damaged cord or if the iron has been dropped or damaged. To avoid the risk of electric shock, do not disassemble the product, but telephone Morphy Richards for advice. [. . . ] IMPORTANT: Always use the funnel supplied, do not take the boiler to a tap. WARNING: Never use water from battery topping up fluid or water containing any substance such as starch or sugar or defrosted water from a refrigerator. 5 Replace the boiler filler cap by screwing on but don't overtighten. If the filler cap whistles, it is not tight enough or the filler cap has not been positioned correctly. In this case switch off the boiler, allow it to cool, then reposition the filler cap correctly. 6 Take care not to overfill if the steam generator contains water. > < fl  , fi , , Á · Iron unit / Steam button ¤ Temperature control dial < Sole plate > Iron ready indicator light fi Supply cord from base unit Ê Steam on/off indicator light Base unit fl Filler cap Power cord · Power switch , Refill indicator (Boiler tank) , , Boiler ready light indicator Variable steam control  Iron/boiler selection switch Á Funnel for filling A Location Locate the steam generator horizontally 4 St gen rn42370M rev 3 31/5/05 10:10 AM Page 5 Using 1 Plug in at the mains socket. · Check to see the iron/boiler selection switch  is set to boiler. · Check to see that the steam on/off indicator light is 'off'. 2 Press the power switch · to the 'on' position, the indicator light in the middle of the switch will illuminate. Ensure that the iron temperature control ¤ is at the correct setting for the material you are ironing. The generator will be ready to use for ironing when the boiler ready indicator , , illuminates and the iron ready light > on the iron goes off. · During ironing, the iron ready indicator and the steam ready indicator will cycle on-off. If they don't you should follow the fabric guide on the control dial of the iron, be sure to test the temperature by ironing the hem of the garment or similar area first. If you turn the control dial down from a hot setting to a cooler setting, wait until the iron temperature has stablilised before you continue ironing. 5 Important note: If the product is accidentally switched off while ironing the boiler controls require approximately 21/2 minutes to re-set before steam ironing can be resumed. Steam ironing 1 Ensure that you have filled the boiler correctly. 2 Consult the heat settings chart page 3, and select the position on the temperature control dial that corresponds to the fabric to be ironed. Wait until the light goes out and the boiler ready indicator on the base unit , , illuminates before ironing. 3 To obtain steam, press the steam control button / and release, the indicator light Ê will illuminate. · It is recommended that everytime the iron is used, the steam control button be depressed away from the ironing board. This process should also be applied when you have not used steam for several minutes. · Alternatively you should first iron on a towel to absorb any excess water droplets. · Note: Water droplets will be discharged through the soleplate if you have overfilled the boiler. [. . . ] 4 Where the appliance has been used for hire purposes or non domestic use. 5 Morphy Richards are not liable to carry out any type of servicing work, under the guarantee. 6 Plastic filters for all Morphy Richards kettles and coffee makers are not covered by the guarantee. This guarantee does not confer any rights other than those expressly set out above and does not cover any claims for consequential loss or damage. [. . . ]