User manual MORPHY RICHARDS IB42345

[. . . ] · To prevent damage to the textile being ironed, follow the temperature guide carefully. · When ironing is complete, remove the plug from the socket and allow to cool before storage. · If you drop or severely knock your steam station this could cause internal damage even if the outside appears alright. · It is recommended that everytime the steam station is used the steam button is depressed away from the ironing board for approximately 30 seconds. [. . . ] WARNING: When filling your steam station with tap water always use the funnel provided. A fl fi < > / Steam on/off button ¤ Filling cap < Removable anti-scale cartridge > Anti-scale release button fi Water tank fl Power cord Temperature dial with indicator · Temperature indicator light , Supply cord , , Steam on/off indicator light Filling funnel Before use Note: The steam facility should only be used on garments which are suitable for ironing at the 3 dot setting. Clothes can be steam ironed at the 2 dot setting, but only for a short period. If they don't you should follow the fabric guide on page 3, but be sure to test the temperature by ironing the hem of the garment or similar area first. If you turn the control dial down from a hot setting to a cooler setting, wait until the steam station temperature has stabilised before you continue ironing. Temperature control Plug in the steam station and switch on. Set the temperature control dial on the iron B to the temperature required, but don't start ironing immediately. B 4 42345 Rev 2 31/5/05 9:39 AM Page 5 If you wait a few minutes, the steam station will stabilise at the required setting. Your Morphy Richards iron is fitted with an indicator light · which will go on and off while you are ironing. This is perfectly normal as it shows that the iron is maintaining the heat setting you have chosen. It is always a good idea to begin with cool fabrics and work up to higher settings. An iron heats up quicker than it cools down so you'll save time and electricity. Anti-scale system The anti-scale cartridge is designed to reduce build-up of limescale which occurs during steam ironing, this will prolong the working life of your steam station. However please note that the anti-scale cartridge will not completely stop the natural process of limescale build-up. Anti-scale cartridge replacement 1 Press the release button to the side of the cartridge. C C Features of your iron Temperature indicator light The indicator light shows that the iron is warming up. When the required temperature is reached the light will go out and will cycle on-off during operation. 'Click' on - 'click' off steam button To activate the steam press the steam button / once and release. The indicator light , , will illuminate, indicating the iron is in steam mode. The first time you use the steam station, it will take approximately 30 seconds for the steam to start. Note: When the tank needs re-filling with water the pump will become noisy. This is quite normal but the tank should be immediately filled with water. Failure to do so could damage the steam system. 2 Lift out the old unit and replace with a new one. How often you need to replace your anti-scale cartridge depends on how often you use your iron with its steam functions and how `hard' your water supply is. [. . . ] 4 Where the appliance has been used for hire purposes or non domestic use. 5 Morphy Richards are not liable to carry out any type of servicing work, under the guarantee. 6 Anti-scale cartridges for all Morphy Richards irons, steam generators are not covered by the guarantee. This guarantee does not confer any rights other than those expressly set out above and does not cover any claims for consequential loss or damage. [. . . ]