User manual MORPHY RICHARDS IB40660

[. . . ] · WARNING: when not in use, your iron should never be placed flat and left on an ironing board. · To prevent damage to the textile being ironed, follow the temperature guide carefully. · When ironing is complete, remove the plug from the socket, empty any remaining water from the tank, and allow to cool before storage. · If you drop or severely knock your iron this could cause internal damage even if the outside appears alright. [. . . ] If you wait a few minutes, the iron will stabilise at the required setting. Your Morphy Richards iron is fitted with an indicator light which will go on and off while you are ironing. B Before use Note: The steam facility should only be used on garments which are suitable for ironing at the 2 and 3 dot settings. When ironing with the steam facility at the 2 dot setting, the steam output should be set at the lower end of the steam range (see variable steam section). If they don't you should follow the fabric guide on page 3, but be sure to test the temperature by ironing the hem of the garment or similar area first. If you turn the control dial down from a hot setting to a cooler setting, wait until the iron temperature has stabilised before you continue ironing. 4 turbo steam RN40655 Rev 1 23/7/04 1:34 PM Page 5 This is perfectly normal as it shows that the iron is maintaining the heat setting you have chosen. It is always a good idea to begin with cool fabrics and work up to higher settings. An iron heats up quicker than it cools down so you'll save time and electricity. C lower steam higher steam Features of your iron Temperature indicator light The indicator light under the control knob shows that the iron is warming up. When the required temperature is reached the light will go out and will cycle on-off during operation. Make sure the variable steam control < is set to the `0' symbol. The spray feature may be used provided there is water in the tank (see filling section). Spray Press the spray button ¤ and aim the spray of water at stubborn creases. You can do this whilst dry ironing providing there is water in the tank. When using the water spray it may be necessary to push the button a few times to get the spray pump primed. Variable steam Fill the iron with water as described in `Filling', page 4 and insert the plug into the electrical socket. The steam output can be varied from low to high by sliding the variable steam control C. When using the iron at the bottom of the steam range, the steam output should be adjusted to the lowest setting. The steam facility should only be used on garments which are suitable for ironing at 2 and 3 dot setting. Shot of steam Press the shot of steam button / to obtain a burst of extra steam for ironing out creases in heavy material such as denim etc. The shot of steam can be used whilst dry ironing, providing there is water in the tank, and the temperature control is set within the steam range. Do not use shot of steam at temperatures below the steam range shown on the control. Note: For optimum steam quality, do not operate the shot more than three times in succession. Vertical steam Hold the iron in a vertical position between 1cm and 2cm away from the item D. [. . . ] Apply a small amount to the soleplate, rub and then remove with a damp cloth. In the unlikely event of any appliance proving to be faulty within 28 days of purchase it should be returned to the place of purchase for it to be replaced. If the fault develops after 28 days and within 24 months of original purchase, you should contact the Helpline number quoting Model number and Serial number on the product, or write to Morphy Richards at the address shown. You will be asked to return the product (in secure, adequate packaging) to the address below along with a copy of proof of purchase. [. . . ]