User manual MORPHY RICHARDS IB40312

[. . . ] · To prevent damage to the textile being ironed, follow the temperature guide carefully. · When ironing is complete, remove the plug from the socket, empty any remaining water from the tank, and allow to cool before storage. · If you drop or severely knock your iron this could cause internal damage even if the outside appears alright. · It is recommended that you use up one beaker of water by operating your iron's steam and shot of steam functions before ironing any clothes as some dripping may occur while your irons steam system is activated. Location · Do not use outdoors. Children · Close supervision is necessary when any appliance is used near children. Personal safety · Burns can occur from touching hot metal parts, hot water or steam. [. . . ] WARNING: When filling your iron with tap water always use the beaker provided. A < > / , fi fl · , , / Steam control ¤ Spray button < Shot of steam button (certain models only) > Filling hole with cap fi Spray nozzle fl Soleplate Temperature control dial with indicator · Water tank , Temperature indicator light (red) , , Filling beaker Before use Note: The steam facility should only be used on garments which are suitable for ironing at the 2 and 3 dot settings. When ironing with the steam facility at the 2 dot setting, the steam output should be set at the lower end of the steam range (see variable steam section). If they don't you should follow the fabric guide on page 3, but be sure to test the temperature by ironing the hem of the garment or similar area first. If you turn the control dial down from a hot setting to a cooler setting, wait until the iron temperature has stabilised before you continue ironing. Temperature control Plug in the iron and switch on. Set the temperature control dial B to the temperature required, but don't start ironing immediately. If you wait a few minutes, the iron will stabilise at the required setting. Your Morphy Richards iron is fitted with an indicator light , which will go on and off while you are ironing. B 4 40310 Rev 1 31/5/05 9:09 AM Page 5 This is perfectly normal as it shows that the iron is maintaining the heat setting you have chosen. It is always a good idea to begin with cool fabrics and work up to higher settings. An iron heats up quicker than it cools down so you'll save time and electricity. C Steam No steam Features of your iron Temperature indicator light The indicator light shows that the iron is warming up. When the required temperature is reached the light will go out and will cycle on-off during operation. The spray feature may be used provided there is water in the tank (see filling section). Spray Press the spray button ¤ and aim the spray of water at stubborn creases. You can do this whilst dry ironing providing there is water in the tank. When using the water spray it may be necessary to push the button a few times to get the spray pump primed. Steam control Fill the iron with water as described in `Filling', page 4 and insert the plug into the electrical socket. The steam output can be switched from off to on by sliding the steam control C. / The steam facility should only be used on garments which are suitable for ironing at 2 and 3 dot setting. Shot of steam (certain models only) Press the shot of steam button < to obtain a burst of extra steam for ironing out creases in heavy material such as denim etc. The shot of steam can be used whilst dry ironing, providing there is water in the tank, and the temperature control is set within the steam range. Do not use shot of steam at temperatures below the steam range shown on the control. [. . . ] Do not store in the box, but in an upright position, so that any drops of water remaining cannot leak out and discolour the soleplate. Important: The flex can be damaged if wound too tightly around the iron after use. The iron must be cool before winding the flex and storing on its heel. 6 40310 Rev 1 31/5/05 9:09 AM Page 7 Helpline If you have any difficulty with your appliance, do not hesitate to call us. We are more likely able to help than the store from where you bought it. [. . . ]