User manual MORPHY RICHARDS IB34050018

[. . . ] In case of doubt the plug should be fitted by a qualified electrician or competent person as the guarantee offered on this product does not cover any fault in the plug or damage caused to the appliance as a result. (If a fused 3-pin 13A plug is used a standard 13A fuse should be fitted). Mains cable/supply cord NOTE: If the supply cord is damaged it must be replaced by a special cord or cord rewind assembly available from your nearest Service Agent. A list of Goblin Authorised Service Agents is supplied separately. Important user information This product has been designed with your safety in mind. However, for safe operation, it is important that you observe the following points: · Never pick up liquids or damp materials. [. . . ] Other accessories are stored in the back of the cleaner and include: · upholstery nozzle for stairs, furniture; · crevice tool for awkward places, behind radiators etc. B Automatic cable rewind (certain models) Reel out the cable fully. After use, unplug and press the foot pedal ·, holding the plug until fully rewound. On/off The on/off control is operated by the foot pedal , . Electronic power control (certain models) This is a rotating knob , , which allows the suction power of the cleaner to be set at the precise level required. For example: Replacing/emptying the dustbag To obtain the best results from your cleaner be sure to change the dustbag when necessary, otherwise the airflow and cleaning power will be reduced. When the dustbag condition indicator > shows fully red and performance deteriorates, first check if there are any blockages in the accessories or tubes. If these are clear, it is necessary to replace/empty the dustbag. C Paper dustbags 1 Remove the hose end from the hose inlet. 2 Slide the dustbag compartment lid release ¤, lift and remove the cover. 3 Pull the cardboard seal up, to close the opening to prevent dust spillage C. 4 Remove the dustbag from its location by pulling the dustbag securing tab  as shown D. 5 Insert the new dustbag into position ensuring the cardboard collar is firmly secured at the base as shown F. 6 Pull forward as shown G so it locks under the plastic securing tab at the top. 8 Relocate the lid at the front (carrying handle /) end first and then close the cover securely. Note: The securing tab  prevents the cover being closed unless a dustbag is fitted correctly. D E Permanent dustbag E 1 Remove the hose end from the hose inlet. 2 Slide the dustbag compartment lid release ¤, lift and remove the cover. 3 Pull the plastic seal up, to close the opening to prevent dust spillage C. 4 Remove the dustbag from its location by pulling the dustbag securing tab  as shown D. 5 Hold the dustbag over a dustbin and slide the clip from the bottom of the bag E and tip the contents of the bag carefully into the bin. Shake the bag vigorously to remove excess dust. 6 Slide the clip back onto the bottom of the dustbag and replace the dustbag into position ensuring the collar is firmly secured at the base F. 7 Pull forward as shown G so it locks under the plastic securing tab at the top. 8 Important Ensure the plastic seal is pushed down otherwise it will not be possible to fit the hose. 10 Relocate the lid at the front (carrying handle /) end first and then close the cover securely. [. . . ] Dirty filters can damage your cleaner and are not covered by the guarantee. 2 Check that the plug is firmly in the socket and the supply is switched on. 4 If the socket is working but the motor is still not running, check or replace any fuses and check that all plug connections are sound. Note the serial number of your cleaner and retain your receipt should it be required as proof of purchase. [. . . ]