User manual MORPHY RICHARDS IB26005

[. . . ] All Morphy Richards products are individually tested before leaving the factory. In the unlikely event of any appliance proving to be faulty within 28 days of purchase it should be returned to the place of purchase for it to be replaced. If a fault develops after 28 days and within 24 months of original purchase, you should contact the helpline number quoting the model number of the product, or write to the address below. [. . . ] Place a towel around the neck of the person, to prevent hair from falling down inside the collar. Position the person whose hair is to be cut on a chair so that his/her head is at your eye level. Comb the hair to remove all tangles. the hair as your guide, slowly move the clipper over, around and behind the ears. For the back of the neck and side burns, hold the clipper upside down and holding it against the skin at the desired length, move downwards. Short cuts to perfect crew cuts Always cut from the back of the neck to the crown, using the longest attachment comb. Holding it flat against the head, slowly move the clipper up through the hair. Using the same technique for the sides, cutting from the bottom to the upper side of the head. B oil brush scissors E Cutting hair with attachments (for medium to long cut) To attach combs, hold comb with teeth up, snap comb attachment firmly to the bottom of the clipper blade. power screw Attachment Attachment Attachment Attachment comb comb comb comb 1 2 3 4 Leaves Leaves Leaves Leaves hair hair hair hair approx. 3mm in length 6mm in length 9mm in length 12mm in length Maintenance Your clippers were examined to ensure that the blades were oiled and aligned before leaving our factory. Blades must be realigned if they have been removed for cleaning or replacement. To realign the blades, simply match the upper and bottom blades teeth up, point for point. If blade alignment is incorrect, add a few drops of oil to the blades, turn the clipper on for a few moments, turn off and unplug. To maintain the clipper in peak condition, the blades should be oiled every few haircuts. Do not use hair oil, grease, oil mixed with kerosene or any other solvent. Solvent will evaporate and leave the thick oil, which may slow down the blades. [. . . ] Then, slowly power turn the power screw out screw (counter-clockwise) just until noise stops. This is the maximum power setting. Adjustable lever The lever is conveniently located near your thumb (if you are right handed), so that it can be easily adjusted while the clipper is in your hand. The lever adds versatility to your clipper by allowing you to gradually change the closeness of your cut without an attachment comb. [. . . ]