User manual MORPHY RICHARDS CYCLONIC BAGLESS VACUUM CLEANER REV 4

[. . . ] If the cleaner is knocked over, switch off before attempting to upright. Never pick the cleaner up by the floor nozzle when connected to the mains, use the carrying handle. · · Location · · Do not use or keep this product outside in the rain. · · Do not store the appliance near hot surfaces eg ovens or heating appliances. · Children · Children do not understand the dangers associated with operating electrical appliances. Never allow children to use this appliance. Mains lead · Do not allow the mains lead to become strained or run this appliance over it. [. . . ] IMPORTANT: Turning the cleaner sideways helps prevent the cleaner being pulled along by the stretch hose. 6 7 Empty out the dust canister Ó. Re-fit the central mesh filter. D 6 · 8 Shake the pleated filter to remove all dust. 9 Re-fit pleated filter with lid into the dust canister by lining up the two arrows and turning the lid 1/4 turn clockwise to lock. · 10 Re-fit dust canister into cleaner and push to lock into position. Then re-fit front cover. Using & cleaning turbo nozzle (Certain models only) Attach the turbo nozzle to the hose end connector Í for use on upholstery and stairs. If they are tightly wound around the brush carefully snip the fibres with scissors, being careful not to damage the brush bar, pull away from the brush bar and dispose. E EMPTYING Empty the dust canister regularly even if it does not look full this will maintain the performance. 1 2 Remove the front cover by lifting the cover release lever ¤ E. Lift-up the dust canister release Î and pull the canister away from the main body. Turn the lid 1/4 turn anticlockwise to unlock, lift off the lid with pleated filter, Ì put to one side. F Lift out the central mesh filter Ô from the dust canister Ó G. Brush clean if necessary. F 3 4 5 www. morphyrichards. com 5 73360 rev4 11/7/06 14:43 Page 6 G SAFETY CUT-OUT If the cleaner overheats a motor protection thermostat will automatically switch the motor off. If this happens, switch the cleaner off, unplug from the power supply and leave the cleaner to cool for at least 60 minutes. Check the airways for blockages, empty dust canister and clean the filters before restarting. Exhaust filter I The exhaust filter is located below the dust canister compartment. Remove the exhaust filter Ú by pulling forward at the top and lift it away. Replace the filter and front cover. 3 H CLEANING THE FILTERS To maintain suction the pleated filter must be shaken clean each time the dust canister is emptied. Failure to clean the filter will reduce suction and could damage the motor if used for a prolonged period. If the filters become damaged they must be replaced. 4 Changing the belt If the brush bar stops rotating it is likely that the drive belt has snapped (usually because the brush has been stalled). Replacement belts can also be obtained from Morphy Richards. I Pleated filter This must be shaken clean at every emptying to maintain suction. To remove it from the dust canister lid turn the filter 1/4 turn anti-clockwise. G Wash in warm water (no detergent) and allow to air dry before refitting. The spare pleated filter allows one filter to be washed and dried whilst the other is in use. 1 2 3 4 Accessing the floor nozzle I Disconnect the cleaner from the mains supply. Press the handle release pedal and place the cleaner face down, in a flat position on a soft surface (eg carpet). [. . . ] This guarantee does not confer any rights other than those expressly set out above and does not cover any claims for consequential loss or damage. This guarantee is offered as an additional benefit and does not affect your statutory rights as a consumer. 5 6 · EXCLUSIONS The fault has been caused or is attributable to accidental use, mis-use, negligent use or used contrary to the manufacturers recommendations or where the fault has been caused by power surges or damage caused in transit. The appliance has been used on a voltage supply other than that stamped on the products. Repairs have been attempted by persons other than our service staff (or authorised dealer). This guarantee is valid in the UK and Ireland only. 2 3 For electrical products sold within the European Community. [. . . ]