User manual MORPHY RICHARDS 70460 GRIMEBUSTER INSTANT STEAM CLEANER

[. . . ] · Use only genuine Morphy Richards spare parts and accessories. · If the electrical cable becomes damaged the complete cable assembly must be replaced. Do not attempt this task yourself, contact Morphy Richards using the replacement parts number on the front of this leaflet. Misuse or use for commercial or any other purpose will render the guarantee invalid. [. . . ] The switch will illuminate and the boiler will take 60 seconds to heat up. This is to keep the steam at the correct temperature. Filling the water tank 1 To fill, release the tank latch B and slide the tank backwards from the rear of the cleaner. 3 Fill to the 'max' line with water E. B E C F D G 4 70460 Rev 2 10/8/04 10:44 AM Page 5 3 Switch the steam switch , to on and this will now illuminate. Steam trigger WARNING: At the start water may be ejected. When the lock is pushed towards the rear the trigger cannot be activated. 2 When you press the steam trigger, steam will be emitted from the nozzle. H 3 There will be an initial delay of a few seconds before the water reaches the boiler. This delay is indicated by the pump noise and reduces as water enters the system. IMPORTANT: On the first use it may take up to 30 seconds before steam is released. If steam is not released within 30 seconds remove and refit the tank, then re-try. 4 Keep the steam trigger pressed and direct the steam at the surface to be cleaned, removing the dirt by moving the steam jet backwards and forwards over the area. 5 To stop the steam jet, release the steam trigger. There will be a delay before the steam ceases as the remaining water in the system is expelled. 6 When the water reaches a low level the pump will click, this is due to air being pumped instead of water. Stop using the appliance, locate the steam nozzle in a safe location and refill the tank. IMPORTANT: If the pump is run dry for a long period it may become air blocked. If this happens, switch off or leave the unit to fully cool before re-trying. Attaching tubes and handle WARNING: Allow all parts to cool and make certain steam has stopped before attempting to fit or change any accessories. large floor brush, jet nozzle or the extension tube directly to the hose handle depending on the application. H I 5 70460 Rev 2 10/8/04 10:44 AM Page 6 3 To join extension tubes together, slide one tube into the other until it locks in place J. 5 To connect the desired accessory directly to the hose handle, slide the handle into the accessory head until it locks in place K. Use of accessories Steam handle To avoid spurting of heavy and moist steam it is recommended to always attach an accessory to the steam handle. Large floor brush Recommended applications include, carpets, rugs, sealed timber, parquetry, ceramic tiles and vinyl. Cotton cloth Stretch the cloth over the bristles using the clips provided on the brush head M. Switch on the steam and move the cloth covered brush gently over surfaces to be cleaned. [. . . ] Abrasive cleaners should not be used. Helpline If you have any difficulty with your appliance do not hesitate to call us. We are likely to be more help than the store from where it was bought. Please have the following information ready to enable our staff to help you. · Name of product · Model number as shown on the underside of the appliance. Anti-scale cartridge filter IMPORTANT: To prevent scale build-up inside the heater the anti-scale filter must be replaced regularly. [. . . ]