User manual MOOG PIANOBAR

[. . . ] IMPORTANT SAFETY INSTRUCTIONS WARNING ­ When using electric products, basic precautions should always be followed, including the following: 1) Read all the instructions before using the product. 2) Do not use this product near water ­ for example, near a bathtub, washbowl, kitchen sink, in a wet basement, or near a swimming pool or the like. 3) This product, in combination with an amplifier and headphones or speakers, may be capable of producing sound levels that could cause permanent hearing loss. Do not operate for a long period of time at a high volume level or at a level that is uncomfortable. [. . . ] Changes made to these Setups are instantly remembered; no saving process is required. Should you wish to return the PianoBar to the original settings, you will have to back these Setups to Library Cards (60 Setups require 3 Library Cards). Backing up the Setups is performed with the Library Function "Setups _ to _ Copy to _ to _" described on page 25 of the manual. Before copying Setups 22 to a Library Card, it must be formatted, done with the Library Function "Format Card". These Setups are blank unless a PianoBar Card with Setups stored on it is inserted in the card slot on the front of the Control Module. To store Setups on a card, simply copy a Setup to a location from 6180 with a formatted Library Card inserted in the Card slot. EDIT MENU The Edit Menu is asked by pressing the Enter/Edit button when on the Main Setup Page. Getting back to the Main Setup page is done by pressing the Escape button. The Edit Menu looks like this: Each item in the Edit menu is a different set functions for the Piano Bar. There are a total of edit functions: · Library ­ abbreviated as "Lib" · Channel Setup ­ abbreviated "ChnSetup" · Controllers ­ abbreviated as "Cntrlrs" · Effects · Channel Route ­ abbreviated "ChnRoute" · Options of six as as The overall architecture is shown on page 19. To access any of the Edit functions, simply move the cursor using the Cursor buttons underneath the Function to be accessed and press Enter. Returning to the Edit Menu from any of the Functions is accomplished by pressing the Escape button. 23 LIBRARY The Library Edit function is used to name and manage the location of Setups and Create Library Cards There are a total of 10 Library functions. Placing the cursor under the function and rotating the Value control selects the different functions. The following are the functions and how they work: Name: This allows you to copy the current Setup to another one of the 80 user accessible memory locations. Copying to a setup between 61-80 copies the setup to a library card ­ if there is a library card plugged into the slot. First, select the desired destination location where the current Setup will be copied. The display will prompt to press Enter to complete the process or press Escape to cancel. Swap with Setup: The Setup Name and Number are displayed, along with the current Library function, Name. With the cursor placed underneath the function, Press Enter/Edit to Begin naming the preset. Use the cursor buttons to move the cursor to the desired position and the Value control to change characters. Copy to Setup: This allows you to swap the current Setup with another. With the cursor placed underneath the function, Press Enter. 24 You will be prompted to press Enter to complete, or press Escape to cancel. [. . . ] This is the Value that turns portamento on. 37 -Advance the cursor to the Channel 1 location it should say "B". Move the cursor to the Channel 3 location set this to "I" for internal. - Move the cursor to the right of "B#" and increase the MIDI CC number to 5. -Advance the cursor to the Channel 1 location it should say "B". [. . . ]