User manual MIO C220

[. . . ] 6 Connecting the Car Charger . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Operating Basics . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Turning On and Off . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Navigating on the Screen. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] A minimum of 4 GPS satellite signals is needed to calculate your GPS position. Signal reception can be affected by weather events or overhead obstacles (e. g. Other wireless devices in the vehicle may interfere with the reception of satellite signals and cause the reception to be unstable. iii A device holder is needed when using the device in a car. Be sure to place the device in an appropriate place, so as not to obstruct the driver's view, or deployment of airbags. Do not mount where the driver's field of vision is blocked. Do not place on the dashboard unsecured. Do not mount in front of airbag panels. Do not mount in front of an airbag field of deployment. iv 1 Getting Started 1. 1 Understanding Hardware Components NOTE: Depending upon the specific model purchased, the color of your device may not exactly match the device shown in this manual. Front Components Ref Component Touch Screen Description Displays the output of your device. Tap the screen with your stylus to select menu commands or enter information. Charge Indicator Flashes bright amber to indicate that the battery is charging, and turns green when the battery is fully charged. 1 Back Components Ref Component Speaker Description Sends out music, sounds and voice. Right-side Components 2 Ref Component SD/MMC Slot Headphone Connector Description Accepts an SD (Secure Digital) or MMC (MultiMedia Card) card for accessing data such as map data. Connects to stereo headphones. Top Components Ref Component External Antenna Connector Power Button Description This connector (under rubber dust cover) allows use of an optional external GPS antenna with magnetic mount, which may be positioned on top of the car for better GPS signal reception in areas with poor reception. Turns on and off the device. Bottom Components Ref Component Description Mini-USB Connector Connects to the USB cable or in-car power cable. 3 1. 2 Performing the Initial Start Up 1. For the initial start up, press the power button for 10 seconds to turn on your device. NOTE: For normal operation, briefly press the power button to turn on and off your device. 3. You can now use your device. 5 1. 3 Using Your Device in a Vehicle Using the Device Holder CAUTION: Select an appropriate location for the device holder. Never place the holder where the driver's field of vision is blocked. If the car's windshield is tinted with a reflective coating, an external antenna (optional) may be needed to route the antenna to the top of the car through a window. When closing the car window, be careful not to pinch the antenna cable Use the device holder to fix your device in a vehicle. Make sure that the GPS antenna has a clear view of the sky. Connecting the Car Charger The car charger supplies power to your device when you are using the device in a car. CAUTION: To protect your device against sudden surges in current, connect the car charger only after the car engine has been started. 1. Connect one end of the car charger to the power connector of your device. Connect the other end to the cigarette lighter in the car to power and charge your device. The indicator on the car charger lights in green to indicate that power is being supplied to your device. 6 CAUTION: For optimal performance of the lithium battery, take note of the following: Do not charge the battery where the temperature is high (e. g. If you will not use the product for a long period of time, be sure to fully charge the battery at least once every two weeks. NOTE: Your device can also be charged when it is connected to a desktop computer via the USB cable. If you intend to charge your device in this way, turn off your device so that it takes less time to charge the battery. 1. 4 Operating Basics Turning On and Off For normal operation, turn off the device by briefly pressing the power button. The device enters a suspended state. When you next briefly press the power button, the system resumes. You will either be back to where you left off or see the Home screen. NOTE: Pressing the power button for a longer duration has a different effect. [. . . ] Use of another type of charger will result in malfunction and/or danger. This product is intended to be supplied by a LISTED Power Unit marked with "LPS", "Limited Power Source" and output rated + 5 V dc / 1. 0 A". Use a specified battery in the equipment. About the Charger Do not use the charger in a high moisture environment. Allow adequate ventilation around the charger when using it to operate the device or charge the battery. [. . . ]