User manual MINOLTA ZOOM 60

[. . . ] the flash has a high voltage circuit which may cause an electric shock resulting in injury. ⷠKeep batteries or small parts that could be swallowed away from infants. Be careful when around children not to harm them with the product or parts. It may cause a distraction or temporary blindness which may lead to an accident. [. . . ] ⷠIf the camera body is dirty, gently wipe it clean with a soft, clean, dry cloth. ⷠTo clean the lens surface, brush away any dust or sand and then gently wipe the lens surface in a circular motion with a clean cloth or tissue for optics. ⷠStore the camera in a cool, dry, well-ventilated area away from dust and chemicals. For very long periods, place the camera in an airtight container with a silica gel drying agent. ⷠBefore using after prolonged storage, always check the camera's operation to make sure it is functioning properly. ⷠBefore important events or journeys, check camera operation carefully or take test photographs. ⷠKonica Minolta is not responsible for any loss which may occur due to an equipment malfunction. ⷠIf you have questions about your camera, contact your local camera dealer or write to the Konica Minolta distributor in your area. ⷠIf the data panel is blank, turn the camera off and on. If "0" appears alone on the data panel, do not open the back cover. Before shipping your camera for repair, please contact an authorized Konica Minolta Service Facility for details. ) Based on Konica Minolta's standard test method: flash used with 50% of the exposures with fresh batteries. Without batteries Specifications are based on the latest information available at the time of printing and are subject to change without notice. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. [. . . ] press the mode button until flash-cancel indicator is displayed on the data panel. Fill-flash can be used to reduce harsh shadows caused by strong direct light or sunshine. press the mode button until the fill-flash indicator is displayed on the data panel. The self-timer delays release of the shutter for approximately 10 seconds after the shutter-release button is pressed. [. . . ]