User manual MINOLTA REGIUS 110 BROCHURE

[. . . ] The included medium-format film holder uses antinewton glass and includes masks for 6x4. 5, 6x6, 6x7, 6x9. · 12-bit AD converter, so fine detail is captured with a dynamic range. This manual has been designed to help you understand the operation of your scanner. To realize all the benefits of your scanner, please read this manual and the accompanying software manual thoroughly. [. . . ] If no holde rge t is too la mask tha ght fracting li is used, re image de will degra ty. quali 21 ROTATING THE FRAME The image area of the Medium Format Holder MH-M1 can rotate 10 degrees in either direction to compensate for a tilted image composition. By rotating the frame before scanning, the need to rotate the scanned image, thus resampling the pixels, is eliminated. 1. Rotate the carrier as desired. · Use the angle scale on the holder for reference. · With larger film formats, the corners of the frame may not fit in the scanning area when the carrier is rotated. 3. Turn the holding screw clockwise to secure it. 22 INSERTING THE HOLDER INTO THE SCANNER 1. Turn on your computer, then launch the Dimâge Scan Multi software. · The green indicator lamp will blink slowly while the scanner is setting up. 2. Insert the holder into the scanner in the direction indicated by the white arrow on top of the holder. · Do not insert the holder at an angle. 3. Gently push the holder into the scanner until the raised insertion mark is aligned with the film-slot door. · The film holder will be automatically guided in past the mark. · If the holder is not loaded correctly, then eject and reinsert it. EJECTING 1. Press the eject button on the front of the scanner. · The holder will automatically eject partway, then stop. 2. After the optics have been moved, a message will appear asking you to turn the scanner off. Using a flat-head screwdriver, push down and turn the locking pin clockwise until it locks down. · Once the optics have been moved to the locking position through the software, the scanner must perform the set-up operation to return to normal. Set-up can also be initiated by pressing the following keys simultaneously while the software is active: Windows95/NT: Control + Shift + i Macintosh: Command + Shift + i 30 TROUBLESHOOTING Symptom The computer will not start after connecting the scanner. Cause/Action Check that all the SCSI cables are secure. Check that two SCSI devices are not sharing the same address. Reference Page 8 The computer does not recognize the scanner. Was the scanner turned on before the computer was turned on?Windows 95/NT: Check that the SCSI device driver been installed correctly. Double-click on the System Icon, then click on the Device Manager tab. Confirm the appropriate SCSI Controller for your board is listed in the sub-menu. The scanner does not pull in the film holder when loading Eject, then reinsert the holder. The film holder must be inserted to the marks for it to be engaged by the scanner's motor The scanned image is very green or blownout white when using the Medium-format holder. The mask does not fit the image properly. Be sure to use a proper fitting mask that is not too big for the image. There should be no uncovered space between the film and the mask. Pages 18 -21. The indicator lamp glows red. If using a film holder: The accessory panel is open. Page 26. 31 Continued on following page. TROUBLESHOOTING Symptom The indicator lamp is red and blinks rapidly or The scanned image is black. Cause/Action 1. [. . . ] · If using Adobe Photoshop 4. 0 or higher in any Mac OS, do not perform step 7. Insert the Dimâge Scan Multi CD-ROM into the CD-ROM drive, then double click on the Dimâge Scan Multi icon. · The language folders will appear. 2. Double-click on the English folder to open it, then double click on the ColorSync folder. Drag the ColorSyncTM System Profiles folder to the Preferences folder. [. . . ]