User manual MIELE W 1930I WASHING MACHINE OPERATING MANUAL

[. . . ] Operating instructions for the W 1930i Washing Machine To prevent accidents and reduce the risk of damaging the machine, read the Operating Manual before installing or using the machine. ö M. -Nr. 47 2 Guide to the machine Guide to the machine 1 Supply cable 2 High pressure inlet hoses 3 Flexible drain hose, with detachable swivel elbow 4 Detergent dispenser drawer 5 Control panel 6 Adapter strips 7 Inner door panel 8 Four height adjustable legs 9 Access panel for lint filter and drain pump 10 Access panel for emergency drain and door release 3 Guide to the machine Guide to the machine Detergent dispenser drawer Compartment i - for the pre-wash. Compartment p (with lid) - for fabric softener or starch. b c d e "Delay start" button. "ON/OFF" button; to turn machine on or off or to interrupt a program. [. . . ] To clean the filter in the inlet valve: Using a wrench, carefully loosen and remove the plastic hose connector on the inlet valve. Using needle nose pliers, grasp the plastic filter and pull it out of the hose connector. Clean the filter under running water and carefully remove any large particles. Slowly turn on the valve and check for leaks. Using needle nose pliers, withdraw the plastic filter by pulling on the bar (see illustration). The two filters - one at the pressure hose/valve connection and one at the inlet connection to the solenoid valve - must not be removed. 24 Problem solving guide Problem solving guide Any work done on the electrical components of this appliance should only be performed by a qualified and trained person in accordance with all local and national codes and regulations. Unauthorized repairs may result in personal injury and damage to the machine. What to do if, . ­ the fuse or circuit breaker has not tripped. There is power and the "ON" indicator lamp is on, but the program selector has not been turned to the "Finish / Start" position. The "Check p" indicator lamp is flashing, and the program has started. The water inlet is blocked. ­ Turn the program selector to the "Finish / Start" position. ­ Select a program. ­ The inlet valve is not opened far enough. ­ The inlet hose is kinked. ­ The water pressure is too low. Call the Service Dept. The "Check q" indicator lamp is flashing. The drain is blocked. ­ Clean the drain pump and lint trap. ­ Has the drain hose been installed too high?(max drain height = 4 feet) 25 Problem solving guide Problem solving guide What to do if, . the "Pre-wash", "Main wash" or "Rinse 1-2" indicator lamp is flashing? Cause . The "Rinse & hold" indica- The spin speed selector has been set to "Without final spin". The machine detected an imbalance. ­ Redistribute the laundry load. The wash is too wet after the final spin? The child-safety feature is activated, and the program has been changed. The load was not evenly distributed in the drum, and the laundry was spun at a reduced speed to protect the machine. The drain pump or lint trap is clogged. Clean the drain pump or lint trap. The machine shakes during the spin cycle? The four feet are not resting evenly on the floor. The shipping struts have not been removed. 26 Problem solving guide Problem solving guide What to do if, . In spite of adequate water A filter in the water inlet system supply, the water flows slowly is blocked. The water pressure is too low. ­ Clean the filters in the water inlet system. ­ It may help to select "Water plus". [. . . ] The sequence indicator lamps will start flashing in succession after about 30 seconds. A new program can be selected as soon as the "On" lamp is the only one remaining lit. The functions described above can be programmed by the Customer using the steps shown on the following pages. There are other programmable functions which are reserved for Miele Service Engineers. [. . . ]