User manual MIELE W1119I

[. . . ] Operating instructions Washer W 1119 To prevent accidents and machine damage, read these instructions before installation or use. UV M. -Nr. 31 The door will not open when the "Door" button is pressed. 32 Open the door during a power failure or when the drain is blocked . 51 3 IMPORTANT SAFETY INSTRUCTIONS , WARNING - To reduce the risk of Do not wash articles that have been previously cleaned, washed, soaked or spotted with gasoline, dry-cleaning solvents or other flammable substances. [. . . ] ^ Clean the siphon tube. 24 Washer care Cleaning the water inlet filters The washer has two water inlet filters to protect each inlet valve. These filters should be checked and cleaned if necessry every 6 months. This may have to be done more frequently with some water supplies. , Inspect the hose regularly. The hose must be in good condition to withstand high water pressure. The hose should be replaced if there are cracks in the surface, or if it has been otherwise damaged or cut. Cleaning the inlet hose filter ^ Turn off the water valve. ^ Unscrew the inlet hose from the valve by turning he connector counterclockwise using a wrench if necessary. Cleaning the filter in the inlet valve ^ Using a wrench, carefully loosen and remove the plastic hose connector on the inlet valve. ^ Using needle nose pliers, remove the plastic filter (see illustration). Both filters must be put back in place after cleaning. ^ Remove the rubber seal, 1, from the connector. ^ Using needle nose pliers, grasp the plastic filter, 2, and pull it out of the hose connector. ^ Clean the filter under running water and carefully remove any large particles. If water leaks, tighten the bolt. 25 Washer care Clean the drain pump Occasionally, small objects (buttons, coins, etc. ) may become trapped in the lint trap. If the machine does not drain completely, the lint trap should be checked to ensure that it is free of foreign objects. ^ Open the detergent dispenser drawer. ^ Remove and clean the lint trap. ^ Remove the tool. ^ Check that the impeller (in the back of the chamber) rotates freely by spinning with your hand. If the lint trap lid is not tightened securely water will leak out when the machine is used. ^ Open the access panel. 26 Quick Guide Remove this guide for easy reference Please read all instructions, especially the "Important Safety Instructions", before using the washer. Quick Guide 1. Load the laundry Refer to the "Program guide" to determine which program is most suitable for the load being washed. Select wash options (if needed) ^ Turn on the washer using the "On/Off" button. ^ Open the drum door by using the "Door" button. Make sure clothes will not be caught by the door. ^ Press the upper button until the indicator of the desired wash option lights. ^ Press the lower button to select the "Sensitive" wash option. Quick Guide 5. Select Delay Start (if needed) ^ Press the "Delay Start" button. ^ Press the "TEMP" and "SPIN" buttons until the indicator of the desired value lights. Activate the program lock (if necessary) ^ Hold the "START" button until the "Child Lock" indicator lights up. Unload the laundry ^ Open the drum door using the "Door" button. [. . . ] If the machine is being connected only to a cold water supply, both the hot and cold water intake hoses must be attached to the cold water valve through the use of a Y adapter (available at a hardware store). Both hoses must be connected to a water source, or the machine will not function properly. If the water pressure is greater that 145 psi (10 bar), a pressure reducer must be installed. If the water pressure is below 15 psi (1 bar), there will not be enough water available for a complete fill. [. . . ]