User manual MIELE T9820 INSTALLATION MANUAL

[. . . ] Be sure to observe local building codes. ~ It is essential to read all instructions before installing the appliance. ~ Installation, repair and maintenance work should be performed by a qualified installer, service agency or the gas supplier. Work by unqualified persons could be dangerous and could void the warranty. [. . . ] At the same time, turn the locking ring, 2, to the right using another wrench. , The dryer lid cannot be removed. 11 Installation , WARNING Before installation, disconnect the tumble dryer from the electrical supply by shutting off the power main or tripping the circuit breaker. Turn the dryer's gas shutoff valve in the supply line to the OFF position. Disconnect and discard old flexible gas connector and ducting material. 12 Electrical connection , GROUNDING INSTRUCTIONS This appliance must be grounded. In the event of malfunction or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance. This appliance is equipped with a cord having an equipment grounding conductor and a grounding plug. The dryer, when installed, must be electrically grounded in accordance with local codes, or in the absence of local codes, with the National Electrical Codes ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22. 1. WARNING ­ Improper connection of the equipment grounding conductor can result in a risk of electric shock. Check with a qualified electrician, service representative or personnel if you are in doubt as to whether the appliance is properly grounded. The dryer is supplied with a 5' 7" (1. 7 m) 3x14 AWG cord and a NEMA 5-15 P plug, ready for connection to a 120 V, 60 Hz, 15 A AC power supply. If the plug does not fit, have a proper outlet installed by a qualified electrician. , WARNING ­ This dryer is equipped with a three-prong (grounding) plug for your protection against shock hazard and should be plugged directly into a properly grounded three-prong receptacle. Do not cut or remove the grounding terminal from this plug. Do not modify the plug!If it will not fit the outlet, have a proper outlet installed by a qualified electrician. 13 Gas connection , WARNING Installation and service must be performed by a qualified installer, service agency or gas supplier. This appliance must be installed with its own shut off valve in the same room. The valve must be easily accessible to the consumer to turn on or shut off the gas supply after the appliance is installed. During any pressure testing of the gas system this appliance must be disconnected from the gas supply by closing its individual manual shut off valve. Any pipe connections must be made using a thread sealant approved for gas connections. [. . . ] Necessary materials: ­ a wall or window duct (available from Miele) ­ an exhaust hose made of approved non-flammable material , WARNING Do not remove the restriction insert in the vent opening. It may result in poor drying results, damage to the laundry and higher Carbon monoxide emissions. The exhaust duct must not be connected or secured with screws or other fastening devices which extend into the interior of the duct. ^ Install the required connector*, 1, with the exhaust hose or pipe, 2, to the dryer. * The white connector with clips is used for connection to a hose; the gray connector without clips is used for connection to a pipe. 22 Ducting Window connection (example) Wall connection (example) 1 Window duct 2 Connector for the rigid or flexible exhaust hose 1 Wall pipe (Installation sheet supplied with the Miele wall pipe) 2 Connector 3 Rigid pipe 23 Ducting Direct wall connection Necessary materials: ­ a wall pipe ­ flexible foam gasket Dryer top view Dryer side view 1 Wall pipe 2 Flexible foam gasket 1 Wall pipe 2 Flexible foam gasket ^ Connect the flexible foam gasket, 2, to the wall pipe connector, 1. [. . . ]