User manual MIELE T366

[. . . ] rendered useless and the cable cut off directly behind it to prevent misuse. See the "Warning and Safety" section of this booklet for further details. Energy saving tips To avoid unnecessarily long drying times and high consumption of energy: ­ Make sure that your laundry is thoroughly spun before drying. The higher the spin, the greater the savings that can be made in energy and time during drying. ­ Load according to the optimum amount of laundry recommended for the programme being used (see "Programme chart"). [. . . ] A Press the Low temperature button and keep it pressed in whilst carrying out steps B to E. C Slowly turn the programme selector three positions stage by stage in a clockwise direction. Each of the three programme indicator lights must come on one after the other. D Now slowly turn the programme selector six positions stage by stage in an anti-clockwise direction. Each of the six programme indicator lights must come on one after the other. The indicator light for the Low temperature button will flash and a key symbol 0-§ will appear in the display. To deactivate the lock Before you begin, first ensure that: ­ The tumble dryer is switched off. At step E the indicator light for the Low temperature button will stop flashing and the key symbol 0-§ will go out. The electronics are no longer locked. 20 Cleaning and care Cleaning the fluff filter The fluff which is created by the drying process is collected in the fluff filter in the door. * Always check the fluff filter if the Clean out airways indicator light comes on. Cleaning whilst dry Tip: You can also use a vacuum cleaner to remove the fluff. ^ Use your fingers to remove the fluff from the surface of the filter. Remedy ­ Cleaning the fluff filter is usually all that is required. However, if the Clean out airways indicator light does not go out after you have cleaned the filter, then also check all the possible causes described under "The drying process goes on too long or even switches off". To switch off the indicator light: ­ Open and close the door. The vent ducting may be very ­ See "Installation - venting" long, which does not regarding calculating constitute a fault. ­ If very long ducting is used, then programme times will be longer and energy consumption higher. The Clean out airways indicator light can be deactivated (see "Programmable functions"). The programme See above for possible To switch off the indicator stops and causes and their remedies. light: ­ Switch the dryer off and the Clean out airways then back on again. again, contact the Miele Service Dept. 24 Problem solving guide Other problems Problem The drying process goes on too long or even switches off. In some circumstances, the Clean out airways indicator light still comes on, even though the filter is clean. Possible cause Remedy Please check all the possible causes and switch the dryer off and then back on again. Ventilation to the dryer is Open a door or window while insufficient (e. g. [. . . ] The Clean out airways indicator will remind you to clean the filters when a certain amount of fluff has collected in the filters. You will have an idea of which of the four options to select after a few drying programmes. Before you begin, first ensure that: ­ The tumble dryer is switched off. A Press the Start/Stop button and keep it pressed in whilst carrying out steps B-C. [. . . ]