User manual MIELE T 494 C

[. . . ] Operating instructions for condenser tumble dryer T 494 C It is essential to read these operating instructions before installing or using the machine to avoid the risk of accident, or damage to the machine. Q} M. -Nr. . 18 18 18 18 18 19 2 Contents Cleaning and care Cleaning the fluff filters. 34 3 Guide to the appliance Guide to the appliance General view 1 2 3 4 5 6 7 4 Supply cable for electrical connection Condensed water container Control panel Door Condenser unit cover Drain hose for condensed water (if fitted) Four height-adjustable screw feet Guide to the appliance Control panel b"I-On/0-Off" button for switching the appliance on and off. When the machine is switched on, the drum light will come on as you open the door. eAdditional option buttons Indicator lights: on= option selected off= option not selected fProgramme selector can be turned clockwise or anti-clockwise. c"Door" button to open the door/cancel a programme. [. . . ] The machine is delivered with the buzzer switched on, but it can be switched off (see next page). The volume of the buzzer can be altered (the pitch changes at the same time). Select the programmable function "Buzzer"(see next page, points 1 to 6). 2. Release the "START" button when the volume you want is reached. To switch the buzzer off altogether see the next page (points 1 to 0). Memory The additional options selected previously for specific programmes are stored in the machine's memory. The memory programmable function can be used to switch the memory function on or off. Anti-crease Once a programme has ended, the drum will turn at regular intervals to prevent the laundry from settling into creases and folds. This programmable function can be used to switch the memory function on or off. The machine is delivered with the "Anti-crease" function activated. 18 Programmable functions Activating and storing in the memory The programmable functions are activated using the additional option buttons in special combinations with the programme selector to introduce extra features not marked up on the control panel. 7 If the "Machine iron" indicator light comes on, then the chosen function has been activated. 8 Each programmable function can be switched on or off by pressing the "START" button: "Machine iron" indicator light - on = Programmable function activated - off = Programmable function de-activated. 1 Switch the machine off and shut the door. Turn the programme selector to "Finish". 2 Press the "Short" and "Low temperature" buttons in. Hold them there and . . . 9 If you wish to activate a further programmable function, repeat steps 6 to 8. If not: 0 To store in the memory:Turn the programme selector to "Finish" and switch the machine off by pressing the "I-On/0-Off" button. To check whether a programmable function is activated: Carry out steps 1 to 7. switch the machine on by pressing the "I-On / 0-Off" button. 4 Release all the buttons. 5 The "Drying" and "Cool air" indicator lights will flash. 6 Turn the programme selector to one of the following positions: ­ COTTONS / Extra dry for the function "Correcting the drying level" ­ COTTONS / Normal + for the function "Buzzer" ­ COTTONS / Normal for the "Memory function" ­ COTTONS / Hand iron r for the function "Anti-crease" 19 Cleaning and care Cleaning and care Cleaning the fluff filters The fluff which is created by the drying process is collected in the fluff filters in the door and door opening. Clean the filters after every programme to reduce drying time and save energy. These filters should only be removed for cleaning with water. Dry the filters well after rinsing and put back in place. Cleaning the tumble dryer Open the door. Remove the fluff from: ­ the filter in the door ­ the filters in the door opening Do not use any sharp or pointed objects. Remove any fluff from the hollow part of the door holder through the wide slit at the bottom. A cleaning brush is available at extra cost from the Miele Spare Parts Department. If there is a great deal of compacted fluff on the filters, they can be cleaned under hot running water. 20 Disconnect the machine from the power supply. [. . . ] Maximum drain hose length: 3. 00 metres Maximum delivery head: 1. 00 metre Accessories supplied: ­ ­ ­ ­ 2 metre drain hose Hose clamp Adapter sleeve Hose clip Push the drain hose onto the drain outlet. Make sure that the hose is not kinked. Unscrew the hose clip from the drain outlet at the back of the machine. Remove the rubber plug. 30 Installation The dryer is fitted with a non-return valve as standard to prevent water from flowing back into the machine. Connection to wash basin drain outlet (where appropriate) Push the hose clip (1) and the knurled nut connector from the sink drain outlet (2) over the drain hose. [. . . ]