User manual MIELE T 1520

[. . . ] Operating Manual for the T 1520 Vented Dryer In order to protect yourself and avoid damage to your machine, it is absolutely necessary to read the operating instructions prior to installation and operation. ] M. -Nr. 29 2 Guide to the machine Guide to the machine 1 2 3 4 5 Supply cable with plug Control panel Drum door Exhaust connection (right, left or rear) Four height-adjustable legs 3 Guide to the machine Pushbuttons ­ Door This button is used to open the door (does not stay pushed in). ­ ON / OFF When the machine is turned on, the "On" indicator will light up if the door is closed. ­ Buzzer Allows the buzzer to sound when the drum rotates during the anti-crease cycle. [. . . ] pullovers, dresses, pants, etc. , which are not dried adequately in the "Normal" program. load 2. 5 kg Special instructions With blended fabrics consisting of wool and synthetics, consult the manufacturer's instructions, as the wool component may cause the fabric to become matted and shrink. Normal * 2. 5 kg Hand iron 2. 5 kg * This is the program that should be tested according to the EN 61121/A11 Standard. TIMED DRYING warm Type of laundry/fabric Individual items, e. g. load - Special instructions This setting will run the full length of time regardless if the item is dry beforehand. - cool 5 kg 13 USER MAINTENANCE INSTRUCTIONS USER MAINTENANCE INSTRUCTIONS Cleaning and care Cleaning the lint filters The lint is collected by the lint filter in the door. Clean the filter after every program. Cleaning the dryer Before cleaning the tumble dryer; disconnect the machine from the power supply. The dryer can be cleaned using soapy water or a mild detergent (not scouring powder) and dried with a soft cloth. The drum may be cleaned using a suitable stainless steel cleaner following the manufacturer's instructions. Do not use any abrasive substances or scouring pads to clean the machine. Grip the filter by the recessed handle and pull up to remove. Any remaining lint in the hollow part of the door can be removed through the gap at the bottom. Dry the lint filter before putting it back in place. 14 Problem solving guide Problem solving guide Electrical appliances should only be repaired by qualified personnel. There are, however, minor problems which can be corrected without contacting the Service Department. What to do if, . If so, failure to start may be due to an incorrect program selection procedure. If the "On" indicator lamp does not illuminate, check that: Remedy . . Repeat the switch-on procedure in the correct sequence, as outlined in the "Program Selection" chapter. ­ The machine is plugged in and the fuse or circuit breaker has not tripped. the laundry is not sufficiently dry? The load consists of dissimilar items (size and fabrics). Small loads can be time-dried. Small loads or individual items may cause the program to terminate the cycle prematurely. the "anti-crease" indicator lamp in the sequence indicator display starts flashing?If the indicator lamp starts flashing again, this indicates a fault in the machine. Please contact the Miele Service Dept. 15 Problem solving guide What to do if, . The temperature limiter opened the drum door and caused the machine to turn off automatically. Possible reasons for overheating: ­ The lint filter in the door is clogged. [. . . ] Before installation, disconnect the tumble dryer from the electrical supply, (unplug from the wall socket, or isolate at the main fuse box). Installation at the rear The machine comes supplied with the connector installed on the rear exhaust port. Installation at the left or right side of the machine Each side exhaust port has a framed exhaust cap. The exhaust connection can be made: ­ at the rear or ­ at the left or right side of the machine Only the cap should be removed, and not the frame. Install the exhaust pipes. 23 Installation - venting The shorter the exhaust ductwork, the more efficient the dryer will be. [. . . ]