User manual MIELE T 1322 C

[. . . ] Operating Instructions Condenser Dryer T 1322 C To prevent accidents and machine damage read these instructions before installation or use. UV M. -Nr. 30 2 IMPORTANT SAFETY INSTRUCTIONS , WARNING - To reduce the risk of Do not repair or replace any part of the appliance or attempt any servicing unless specifically recommended in these operating instructions. Repairs to electrical appliances should only be performed by qualified personnel. Incorrectly repaired machines may pose a considerable risk to the user. [. . . ] ^ Take the door lint filters out by turning the knob at the filter top. ^ Open the door and remove the lint filter by gently lifting it upwards. ^ Wipe the lint off the filter with your hand (do not use any sharp objects!) 14 Dryer care Cleaning the exterior and the control panel , To reduce the risk of electric shock, disconnect the dryer from the power supply by shutting off the power main, tripping the circuit breaker or unplugging the power cord before performing maintenance. Never use abrasive cleaners, scouring pads, steel wool or caustic (oven) cleaners on the dryer. They will damage the surface. ^ The exterior and the control panel can be cleaned with warm water and liquid dish soap applied with a soft sponge. ^ Wipe dry. Cleaning the drum ^ The stainless steel surfaces of the drum can be cleaned using a non-abrasive stainless steel cleaner. ^ Wipe clean with a soft cloth. 15 Dryer care Emptying the condensed water container Depending on the installation, the condensed water will either be pumped to a drain or collected in the condensed water container, located in the upper left corner of the machine. Should the container be full when the tumble dryer is started, or if it becomes full during normal operation: ­ The "Container" indicator will light. ^ Pull out the container slightly to the right with both hands. ^ Hold the cap open while emptying the container. ^ When the container is empty, push it back into its opening until it clicks into place. Do not drink the condensed water! 16 Quick Guide Remove this guide for easy reference Please read all instructions, especially the "Important Safety Instructions", before using the dryer. Quick Guide 1. Turn on the dryer and load the laundry 2. Select a program ^ Press the "On/Off" button to turn on the dryer. ^ Press the "Door" button to open the door. Make sure that there is enough space in the drum for clothes to tumble freely. ^ Press the e or - button until the desired program indicator lights. Select a drying option (if needed) To prevent fabric damage, check that laundry will not be caught in the closed door. ^ Close the door with a firm swing - do not push it shut. ^ A drying option can be selected or deselected with each press of the button. Quick Guide 4. At the end of a program The "Anti-crease / End" indicator will light. ^ Press the "On/Off" button to turn off the dryer. Quick Guide Program Normal Extra Dry When to use Available drying options Turbo, Gentle, Anti-crease For laundry to be folded and shelved immediately, e. g. For items to be left damp for ironing. Note The "Extra Dry" program should not be selected for jersey materials. Items may shrink. More Dry Normal Less Dry Hand Iron Rotary Iron If items are still damp, dry again using "More Dry". If fabrics are too damp, dry again using "Less Dry". For items to be ironed with a rotary iron. For items which require ironing. To prevent moisture loss, roll up the laundry until ready to iron. Wrinkle-free Available drying options Turbo, Gentle, Anti-crease More Dry Normal Less Dry Reduce load size for fabrics that wrinkle easily. Special Programs Available drying options: Anti-crease only available in Fluff, Sturdy Woolens Delicate items which allow machine drying. Take items out immediately after the end of the program while still slightly damp. Allow items to air dry. Smooth Sturdy Fluff - TIMED CYCLES 20 min 30 min Available drying options Gentle, Anti-crease - Dryer care Cleaning the condenser , To reduce the risk of electric shock, disconnect the dryer from the power supply by shutting off the power main, tripping the circuit breaker or unplugging the power cord before performing maintenance. ^ Clean the condenser every 6 months. Removing the condenser The access panel to the condenser is located on the lower left corner of the dryer. ^ Turn the condenser door lock down and remove the door. ^ Turn the condenser lock up. ^ Press on the lower corners of the access panel and lower it down. ^ Remove the panel up and out of the condenser access area. ^ Pull out the condenser. 17 Dryer care Rinsing the condenser Returning the Condenser ^ Put the condenser back in place in the reverse order. Check that the gasket around the front of the condenser is flush and not crimped. [. . . ] In the event of malfunction or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance for electric current. This appliance is equipped with a cord having an equipment grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. WARNING ­ Improper connection of the equipment grounding conductor can result in a risk of electric shock. [. . . ]