User manual MIELE T 4839 CI

[. . . ] Operating instructions for condenser tumble dryer T 4839 Ci To avoid the risk of accidents or damage to the machine it is essential to read these instructions before it is installed and used for the first time. G M. -Nr. 06 731 780 Caring for the environment Disposal of the packing material The transport and protective packing has been selected from materials which are environmentally friendly for disposal and can normally be recycled. are disposed of safely and kept out of the reach of babies and young children. Rather than just throwing these materials away, please ensure they are offered for recycling. [. . . ] ­ 3 kg* of minimum iron items made of synthetic or blended fabric. ­ For airing individual items of laundry which are already dry or for deactivating lice, dustmites and micro-organisms in washable materials which are suitable for drying in a tumble dryer, e. g. Weight of dry laundry 24 Changing the programme sequence Changing a programme while it Interrupting a programme is running ^ Switch the dryer off. You cannot change to another programme once a programme has started (this prevents unintentional alterations). If an attempt is made to change a selection, Option not possible will appear in the display. It is still possible to select or deselect the Anti-crease and Buzzer extra options. You will need to cancel the current programme before you can select a new one. The programme will continue, as long as the cooling down phase has not been reached. Adding or removing laundry after a programme has started ^ Press the Door button. ^ Open the door. , Do not touch the back of the drum when adding or removing items. ^ Press the Start/Stop button. Cancelling a programme ^ Press the Start/Stop button. The "Stopped" option Cancel programme will appear in the display. The items will be cooled down, depending on the temperature reached and how long they have been dried for. If you press the Start/Stop button during the cooling down phase and confirm by pressing the right hand Menu button under OK, Finished will appear in the display. ^ You can now select a different programme. Note The time remaining shown in the display may now vary from the actual drying time. 25 Cleaning and care Emptying the condensed water container The condensed water will be collected in the condensed water container unless the appliance has been fitted with a drain hose (see installation). The drying programme will be interrupted if the maximum level of the condensed water container is reached. A message will appear in the display. ^ Open the shutter and empty out the water. ^ To replace the container, hold it at a slight angle (as when removing it) and push it in gently until you feel it click into position. ^ To remove the message from the display, switch the dryer off and then on again. To ensure that any residual particles of fluff in the condensed water are removed before use, pass it through a fine sieve or paper filter first. ^ Holding the container firmly in both hands, as shown, pull it out slightly towards the right-hand side. ^ Hold the container in a horizontal position when carrying it. 26 Cleaning and care Cleaning the fluff filters The fluff which is created by the drying process is collected by the fluff filters in the door and the door opening. Cleaning them whilst dry Tip: You can also use a vacuum cleaner to remove the fluff. You could also use a cleaning brush which is available as an optional extra from your Miele dealer or the Miele Spare Parts Department, or use a vacuum cleaner. ^ Once clean, push the filter back into the door holder until it clicks into position. [. . . ] To set the clock format Clock format 24 h clock B Continue OK Drying levels You can alter the drying levels for the Cottons and Minimum iron programmes. ­ r (drier) The programme duration is longer. ^ Select the clock format you want with the left hand Menu button under Continue, and confirm your selection with the right hand Menu button under OK. To set the time ^ Select the Time sub-menu and use the Menu buttons to set the time. Extended cool down The cooling down phase which takes place before the end of a programme can be lengthened if required. Factory default: 0 mins (normal cooling down period) You can select an extended cool down time in 2 minute increments up to a maximum of 18 minutes. [. . . ]