User manual MIELE T 4162

[. . . ] Operating instructions for vented tumble dryer T 4162 To avoid the risk of accidents or damage to the machine it is essential to read these instructions before it is installed or used for the first time. G M. -Nr. 06 619 190 Caring for the environment Disposal of the packing material The transport and protective packing has been selected from materials which are environmentally friendly for disposal and can normally be recycled. are disposed of safely and kept out of the reach of babies and young children. Rather than just throwing these materials away, please ensure they are offered for recycling. [. . . ] Machine drying hardly causes any fluff to form and has been established by research institutes to have no appreciable effect on the lifetime of the garment. Remedy Fluff is collected by the fluff filter and can be easily removed (see "Cleaning and Care"). The laundry is not sufficiently dry. ­ Finish drying using "Timed drying - Warm air". ­ Select a more suitable drying programme next time (see "Programme chart"). Change the lamp as described at the end of this section. The interior drum The lighting switches off lighting does not automatically (to save come on. The lamp needs changing. 19 Problem solving guide Problem The drying process goes on too long or even switches off. Possible cause Remedy Important: Before attempting to remedy one of the following causes, switch the dryer off and switch on again to start the programme again. Ventilation to the dryer is Open a door or window while insufficient (e. g. because it the machine is in operation for is installed in a room which increased air flow. Remove any fluff. The vent ducting or the ­ Check all parts of the ventilation outlet is blocked. wall vent, external grille, bends in the ducting etc. ) and make sure they are all free of any hindrance. Make sure that your laundry is thoroughly spun at the appropriate spin speed. dryer from registering the If the problem occurs again, correct moisture level in the dry garments with long zips laundry. The laundry has not been spun sufficiently. 20 Problem solving guide Check and fault indicator lamps Problem The programme has stopped. The Anti-crease/Finish lamp has come on in the sequence display and the buzzer is sounding. Warm air" programme to The electronic unit has recognised that there is no dry individual items. or items which are already dry can also cause the programme to be stopped. If the programme stops again and the fault message reappears there is a fault. The indicator lamp for Hand iron or Machine iron is flashing, and the buzzer sounds. 21 Problem solving guide Changing the lamp Disconnect the machine from the mains electricity supply. You will find the interior lamp cover at the top of the drum aperture. The lamp specification and maximum wattage is stated on the data plate and on the lamp cover. ^ To close the cover push it upwards and press it on the left and right until you hear it click into position. , Ensure that it is fitted into position securely, as any moisture could cause a short circuit. ^ Insert a suitable tool, such as a wide bladed screwdriver, under the side edge of the lamp cover as illustrated. ^ Apply a little pressure and whilst doing so turn your wrist in the direction of the arrow to open the cover. [. . . ] The option of extending the cooling down time is available with the Cottons, Minimum iron and Automatic programmes. Before you begin, first ensure that: ­ The tumble dryer is switched off. A Press the Start button and keep it pressed in whilst carrying out steps B-C. F Pressing the Start button alters the cooling down time. 43 ­ If the Drying indicator lamp flashes once: The cooling down time will be five miinutes longer. [. . . ]