User manual MIELE SEB 226

[. . . ] Your power supply should correspond to the voltage rating listed on the data plate of both the powerbrush and the vacuum cleaner. Connecting the vacuum or powerbrush to a higher voltage than indicated on the data plate will damage the powerbrush and may result in personal injury. the accessories are designed for direct connection to Miele vacuum cleaners ONLY. Do not use extension cords, modify the plugs, or attempt to connect any of the accessories to a non-Miele vacuum cleaner. [. . . ] Do not attempt any repairs other than those listed in the "Maintenance and care section. Any other required service should be performed by an Authorized Miele Service Agent. Always unplug the machine before connecting or disconnecting any accessories from the vacuum cleaner. Electric Wand SET 210 The SET 210 is an electric wand that carries power to the Powerbrush through internal cabling. It can be identified by a small plug at the top rear and bottom rear of the wand. A Handle b Release button for suction wand c Height adjustment switch d Brush height indicator e Blockage warning light f Suction wand lock Canister vacuums The connection procedure will vary depending upon which vacuum, electric hose, suction wand and powerbrush model you purchased. Please find the combination of components you have on the following pages and use those instructions to connect the powerbrush to your vacuum cleaner. When vacuuming rug fringes, place the Powerbrush on the rug and pull it over the fringe onto the floor. Never push the Powerbrush over fringes, as they may become entangled in the brush roller. For suggestions and recommendations on which type of Powerbrush or floor tool will work best for your application, please contact your Miele Vacuum Dealer. SEB 217 with an upright vacuum cleaner The Powerbrush will start automatically when the vacuum cleaner is turned on. SEB 217, SEB 213 and SEB 226 The powerbrush can only be turned on if the vacuum cleaner is also on. The switch that controls the power brush can be found on the hose handle, as shown in the illustration below. ^ To achieve the best results, slowly pass the Powerbrush back and forth over the carpet. SEB 213 / SEB 217 indicator light The electrobrush warning light has a double function. It lights ­ green, when the brush is in use ­ red, if the brush roller is blocked. This can occur if enough threads wrap around it or if a large or long object has been vacuumed up. ^ Remove the object preventing the roller from turning (see the "Maintenance and Care" section). ^ Wait approximately 2-3 minutes for this safety feature to reset before turning the vacuum cleaner back on. Warning light , (SEB 226) The Warning light will light if the brush roller is prevented from spinning. [. . . ] The correct orientation of the supports allows the proper length of bristle to protrude from the roller cover. The brush can continue to be used in the "two notch" position until the bristles wear down to the point where they no longer clean. Replacing the roller brush drive belt The Powerbrush housing must be opened in order to replace the drive belt. ^ Remove the roller cover a by loosening the two lock screws on the bottom of the Powerbrush using a coin or screwdriver. [. . . ]